Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. Carefully route the camera cable connector through the
hole and insert the camera into the hole.
4. Wire the cables as indicated on below illustrations
(Important: pay attention to the set you have purchased.
Perform connections according to wiring cables in
your set). Make a permanent connection using a crimp
connector or by soldering etc. Please note the are two
different methods of connecting the camera:
• connect the video output cable (2) to video input on
your vehicle's monitor (1), and connect the red cable
(3) to power (+12 V).
• connect the video output cable (2) to video input
on your vehicle's monitor (1), and connect the red
cable (5) to power (+12 V) and black cable (6) to GND
(recommended method).
2
1
2
1
3
5
6
3
5
6
EN
Owner's manual
4
4
13
Werbung
