Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Owner's manual
•
Before drilling the holes in vehicle's body, make sure
to select location in which you will not damage any
electrical cables, brake system, fuel tank etc.
•
The camera cannot obscure rear lights, license plate nor
any other part of the vehicle.
•
Make sure the camera does NOT stick out of the vehicle.
•
Before drilling a hole, determine the best way to run the
cables through the vehicle. Ensure the cables does not
interfere any safety equipment nor reduce safety of the
vehicle.
DOUBLE CHECK BEFORE YOU DRILL! Look out for cables,
sensors, lines, anything that could get damaged.
Suggested camera installation position:
Rear:
Connection
1. After selecting a mounting spot, remove the panel if
possible, and tape off the area to be drilled with masking
tape in order to protect the surroundings.
2. After drilling, carefully remove any burs or sharp edges
so you do not damage the cable when pulling it through.
12
Front:
EN
Werbung
