Start-Up Of The Device/Introduction; General Operation; Infrared Remote Control - AEG MC 4411 Bedienungsanleitung, Garantie

8 FUNCTION Function selector button
9 MUTE (geluid uit) button
10 VOL-DN/VOL-UP (volume) buttons
11 STEREO/MONO/ESP button
12 POWER button
13 TUNER/BAND button
14 SLEEP button
15 TIMER button
16 EQ button
17 CARD-USB button
18 Number buttons
19 DBBS button
20 INTRO button

Start-up of the device/Introduction

• Read the operating instructions thoroughly before the start-up!
• Select an appropriate location for the device, e.g. a dry, fl at,
non-slip surface on which the device can be easily operated.
• Make sure that the device is adequately ventilated!
• Connect the loudspeakers to the back of the music centre to
the sockets market „Speaker RIGHT and LEFT" (17).
• Insert the plug into a properly installed 230 V, 50 Hz power
socket. Please ensure that the mains voltage corresponds to
the information on the type plate.
• The stored time and stations are lost as soon as the power
supply is interrupted.
Setting the Time (in Standby Mode)
1. Keep the CLOCK/MEMORY button (10/6) pressed down.
The words „24 HOUR" appear in the display.
2. Use the SKIP-UP
choose between the 24 hour and 12 hour display. Press the
CLOCK/MEMORY button (10/6) to confi rm.
NOTE:
The following appears in the case of the 12 hour display
AM = in the morning, PM = in the afternoon/evening.
3. Press the SKIP-UP
to set the hours. Keep the button pressed down until the
desired hour is reached. Press the CLOCK/MEMORY button
(10/6) to confi rm.
4. Press the SKIP-UP
order to set the minutes. Keep the button pressed down until
the desired minutes are reached.
5. Press the CLOCK/MEMORY button (10/6) again to store the
time.
Remote Control Batteries (not supplied)
• Open the lid of the battery compartment on the back of the
remote control.
• Insert 2 batteries of type R03 „AAA" 1,5 V. Ensure that the
polarity is correct (see the fl oor of the battery compartment)!
• If the remote control is not used for a prolonged period,
remove the batteries in order to prevent battery acid leaking.
• Different battery types or new and used batteries must not
be used together.
50
05-MC 4411 AEG 50
I /SKIP-DN I buttons (8/3) to
I /SKIP-DN I buttons (8/3)
I /SKIP-DN I (8/3) button in
CAUTION:
Batteries are not to be disposed of together with domestic
wastes. Dispose of the used batteries at the relevant collection
bin or at your dealer's.
WARNING:
Do not expose the batteries to high temperatures or direct
sunlight. Never throw batteries into the fi re. There is a danger
of explosion!
CD deck transport protection
Please open the CD compartment (11) by pressing the PUSH/
OPEN (open) button (12). Remove the transport protection from
the CD player if present before use.

General Operation

NOTE:
Some keys are to be found both on the device itself and
on the remote control. Keys with the same designation
have the same function.
STANDBY/ON / POWER (4/12)
Switch the device to the standby mode with the STANDBY/ON /
POWER button (the time is displayed). If this button is pressed
once more, the device switches on again.
Volume (5/10)
This is used to set the individual volume. The letters „VOL" and a
fi gure appear in the display (13). This corresponds to the volume
that has been set as far as „VOL 30" or „VOL 00".
PHONES Headphone Socket (1)
Please use headphones with a 3.5 mm stereo jack plug; these
should be inserted into the headphone socket. The loudspea-
kers are then switched off.
DBBS (19 on the remote control)
To increase or decrease the bass output.
BBS ON = on, BBS OFF = off.
INTRO (20 on the remote control)
Press the INTRO button (INTRO appears in the display). Each
track on the CD is played for 10 seconds. Press this button again
to stop searching. The currently selected track is played.

Infrared remote control

For operating the music centre from a distance of up to 5 metres
without a lead. If the range of the remote control is reduced, the
batteries have to be replaced. During operation ensure that there
is nothing blocking the direct line between the remote control
and the sensor (3) on the machine.
USB Connexion (7)
This device has been developed in accordance with the latest
technical developments in the USB fi eld. Unfortunately the large
number of different types of USB storage media on offer today
05.02.2007, 11:09:34 Uhr