Power Supply - eta 978290010F Bedienungsanleitung

If leakage occurs (which can be easily detected due to the unpleasant smell), please:
1.
2.
3.
V. INSTALLATION
• Do not place refrigerator under the direct sun light, high teperature and high humidity.
• Ventilation is very important for this kind thermoelectric cooler; The inside PCB will be
broken easily if the ventilation is bad; It will also reduce the life of the cooler.
• Install refrigerator in a convenient location away from extreme heat and cold.
Allow sufficient clearance between the refrigerator and side wall so the door will
open without obstruction.
• Refrigerator is not designed for recessed installation.
• Select a space with strong level floor.
• Allow 2cm of space between the refrigerators side & wall and 5cm between back & the
wall. At the bottom should be left at least 5cm for air flowing.
• The package includes a handle and 2 screws. Remove (pull up slightly) the black gasket
from the inside of the door. The gasket is flexible enough and covers two screw holes. Insert
the screws from the inside of the door outwards, attach the handle and tighten the screws
well on the inside
• The device have to be accurately leveled with one or more adjustable feet on the bottom of
the device.
Positioning
Install this appliance at a location where the ambient temperature corresponds to the
climate class indicated on the rating plate of the appliance. For refrigerating appliances
with climate class:
- extended temperate: 'this refrigerating appliance is intended to be used at ambient
temperatures ranging from 10 °C to 32 °C (SN)
- temperate: 'this refrigerating appliance is intended to be used at ambient
temperatures ranging from 16 °C to 32 °C (N)
- subtropical: 'this refrigerating appliance is intended to be used at ambient
temperatures ranging from 16 °C to 38 °C (ST)
- tropical: 'this refrigerating appliance is intended to be used at ambient
temperatures ranging from 16 °C to 43 °C (T)

Power supply

• The cooler must be connected to a properly earthed socket in line with relevant valid country
regulations before operating
• Check the data label (which is on the side of the cooler) for voltage and frequency
corresponds to your local on; if not, don't plug your cable into the socket
IMPORTANT
SWITCH OFF the cooler immediately
VENTILATE The room thoroughly
CALL FOR THe after sales service department
EN - 39
EN