Troubleshooting - AEG LAVATHERM 5127AC Benutzerinformation

18 www.aeg.com

12. TROUBLESHOOTING

Problem
The tumble dry-
er does not op-
erate.
Unsatisfactory
drying result.
The loading
door does not
closed
Programme in-
active.
Possible cause
The tumble dryer is not connected
to mains supply.
The loading door is opened.
The On/Off (Aan/Uit) button was
not pushed.
The Start/Pause (/Pauze) button
was not pushed.
The appliance is in the standby
mode.
Incorrect programme selection.
The filter is clogged.
The Dry Plus (Drogen Plus) option
was in minimum level.
Too high volume of the load.
The airflow grill is clogged.
Dirt on the humidity sensor in the
drum.
Incorrect remaining laundry mois-
ture degree.
The condenser is clogged.
The filter not locked in the posi-
tion.
The laundry is locked between the
door and the seal.
The water container is full.
Connect in at mains socket. Check
fuse in fuse box (domestic installa-
tion).
Close the loading door.
Push the On/Off (Aan/Uit) button.
Push the Start/Pause (/Pauze) but-
ton.
Push the On/Off (Aan/Uit) button.
Do the selection of the applicable
programme.
Clean the filter.
Change the Dry Plus (Drogen Plus)
option to the moderate or maxi-
3)
mum level.
Obey the maximum load volume.
Clean the airflow grill in the bot-
tom of the appliance.
Clean the front surface of the
drum.
Adjust remaining laundry moisture
degree.
Clean the condenser.
Put the filter in the correct posi-
tion.
Put the load correctly in the drum.
Drain the water container, push
the Start/Pause (/Pauze) button.
Remedy
1)
2)
3)
4)
2)
2)