Care And Cleaning; Cleaning The Filter - AEG LAVATHERM 5127AC Benutzerinformation

10.2 Adjustment of the
remaining laundry moisture
degree
To change the default degree of the
remaining moisture of the laundry:
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold
down the Delicate (Behoedzaam)
and Anti-crease (Anti-kreuk)
buttons.
LEDs above the buttons are on.
5. Push the Start/Pause (/Pauze)
button again and again until you set
necessary degree.
The are 3 degrees available:
the indicator: Drying (Drogen) is on - the
standard dry laundry is set
the indicator: Cooling (Afkoeling) is on -
the more dry laundry is set
the indicator: End (Antii-kreuk/Einde) is
on - the maximum dry laundry is set
6. To memorise the setting, push at the
same time the Delicate

11. CARE AND CLEANING

11.1 Cleaning the filter

At the end of each cycle the indicator
Filter is on and you must clean the filter.
To clean the filter:
1. Open the door. Pull the filter.
2. Open the filter.
The filter collects the fluff.
The fluff occurs while the
clothes are dried in the
tumble dryer.
(Behoedzaam) and Anti-crease
(Anti-kreuk) buttons for
approximately 2 seconds.
10.3 Deactivating the Water
container (Reservoir) indicator
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold
down the Delicate (Behoedzaam)
and Delay Start (Startuitstel)
buttons.
LEDs above the buttons flash 3 times.
One of 2 configurations is possible:
Water container (Reservoir)
• the
indicator:
container indicator is permanently
on
Water container (Reservoir)
• the
indicator:
container indicator is permanently
off
3. Use a moist hand to clean the filter.
4. If necessary clean the filter with the
brush under warm tap water and/or a
vacuum cleaner. Close the filter.
ENGLISH 15
is on - the water
is off - the water