The First Wash Cycle; Technical Data; Iwde 7145 - Indesit IWDE 7145 Bedienungsanleitungen

Connecting the drain hose

We advise against the use of hose extensions; if it is
absolutely necessary, the extension must have the
same diameter as the original hose and must not
exceed 150 cm in length.
Electrical connections
Before plugging the appliance into the electricity
socket, make sure that:
• the socket is earthed and complies with all
applicable laws;
• the socket is able to withstand the maximum power
load of the appliance as indicated in the Technical
data table (see opposite);
• the power supply voltage falls within the values
indicated in the Technical data table (see opposite);
• the socket is compatible with the plug of the
Washer-dryer. If this is not the case, replace the
socket or the plug.

The Washer-dryer must not be installed outdoors,
even in covered areas. It is extremely dangerous to
leave the appliance exposed to rain, storms and other
weather conditions.

When the Washer-dryer has been installed, the
electricity socket must be within easy reach.
Connect the drain hose,
without bending it, to a
drainage duct or a wall
drain located at a height
between 65 and 100 cm
from the floor;
alternatively, rest it on
the side of a washbasin
or bathtub, fastening the
duct supplied to the tap
(see figure). The free end
of the hose should not
be underwater.

Do not use extension cords or multiple sockets.

The cable should not be bent or compressed.

The power supply cable must only be replaced by
authorised technicians.
Warning! The company shall not be held responsible
in the event that these regulations are not respected.

The first wash cycle

Once the appliance has been installed, and before
you use it for the first time, run a wash cycle with
detergent and no laundry, using the wash cycle 2.

Technical data

Model

IWDE 7145

width 59.5 cm
Dimensions
height 85 cm
depth 53,5 cm
from 1 to 7 kg for the wash programme;
Capacity
from 1 to 5 kg for the drying programme
Electrical please refer to the technical data plate
connections fixed to the machine
maximum pressure 1 MPa (10 bar)
Water
minimum pressure 0.05 MPa (0.5 bar)
connections
drum capacity 52 litres
Spin speed up to 1400 rotations per minute
Wash: programme 2; temperature 60°C;
Energy rated
using a load of 7 kg.
programmes
Drying: first drying cycle performed with
according to
a 2 kg load, selecting drying level "A1"
regulation (IRON DRY); second drying cycle
performed with a 5 kg load, selecting
EN 50229
drying level "A4" (EXTRA DRY).
This appliance conforms to the following
EC Directives:
- 89/336/EEC dated 03/05/89
(Electromagnetic Compatibility) and
subsequent modifications
- 2002/96/EC
- 2006/95/EC (Low Voltage)
GB
3