Assembly - Atag WV6092 Serie Anleitung

INSTALLATION

Assembly

EN 10
Drilling holes in the supporting surface and mounting the hood
• The supporting surface for the hood must be 135 mm higher than
the lower edge of the suspended cabinets.
• Drill a 4.5 mm diam. hole in the support using the supplied drilling
template.
• Drill a 150 mm diam. hole in the supporting surface using the
supplied drilling template.
• Secure with the 4 supplied screws '12a' (4.2 x 44.4).
Mounting the cooker hood in a cabinet without a shelf
• Saw an opening of 510 x 265 cm in the bottom of the cabinet.
• Mount the cooker hood in the cabinet opening using the two quick-
release clamps.
• Mount the cooker hood using the supplied cabinet brackets and
quick-release clamps if the bottom panel of the cabinet is missing.
Closing profile
• The space between the edge of the hood and the rear wall can
be closed with the supplied profile '20' using the screws that are
already available for this purpose.
264
15
2x