Inhaltsverzeichnis
Werbung
5.2.2 Please note that the fan heater can become very hot and should, therefore, be placed at a safe distance from flammable objects such as
furniture, curtains and similar.
5.2.3 Do not cover the fan heater.
5.2.4 The fan heater must not be located immediately below a socket outlet.
5.2.5 Do not connect the fan heater using an on/off timer or other equipment which can automatically switch the device on.
5.2.6 The fan heater must not be placed in rooms where flammable liquids or gases are used or stored.
5.2.7 If an extension cord is used, it must be as short as possible and always be fully extended.
5.2.8 You must not connect other appliances to the same mains socket as the fan heater.
5.2.9 Do not use this fan heater in the immediate surroundings of a bath, a shower or a swimming pool.
5.2.10 If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a
hazard.
5.2.11 Make sure heater is always under surveillance and keep children and animals away from it;
5.2.12 Do not place the appliance on moving vehicles or some where easy to be tipped over.
5.2.13 When you don't use the appliance for a long time, unplug the appliance. Don't leave the heater for a considerable amount of time when in use.
Pull the plug straight out, never remove the plug by pulling on the cord.
5.2.14 Keep the heater far from curtain or places where the air inlet can easily be blocked.
5.2.15 The power coupler is waterproof when not in use. In order to prevent possible electric shock or leakage current ,never use the appliance with
wet hand or operate the appliance when there is water on the power cord.
5.2.16 Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities. Contact you local government for
information regarding the collection systems available. If electrical appliance are disposed of in landfills or dumps, hazardous substances can leak
into the groundwater and get into the food chain, damaging your health and well-being.
5.2.17 This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their
safety.
5.2.18 Children should be supervised to ensure that they do not play with the appliance.
6. Using Instructions
6.1 Position the fan heater so that it stands upright on a firm surface and at a safe distance from wet environments and flammable objects.
6.2 Connect the fan heater to the mains.
6.3 Set the thermostat knob to the MAX and let the heater operate with full power.
6.4 The fan heater will switch on when the heating selector is set to one of the power settings.
6.5 Once the room reaches the required temperature, heating element will stop working.Once the temperature decreased, the heating element will
be working. The fan heater now starts and stops automatically and thus keeps the room temperature constant.
6.6 Before switch off the heater, please turn the thermostat to MIN position and turn the switch to fan position, let the appliance cool down for two
minutes then turn off the heater and pull out the plug.
7. Cleaning and Maintenance
7.1 Before cleaning the appliance,disconnect it from the socket and let it cool down. The enclosure is easily to get dirty, wipe it often with soft sponge.
For every dirty parts, wipe with a sponge dipped in <50°C water and mild detergent,then dry the heater enclosure with clean cloth. Be careful not to
let the water enter the appliance inner. Don't splash water onto the heater,never use solvent like gasoline etc. to clean the heater,in order to protect
the enclosure.
7.2 Clean the cord and plug,dry and pack it in a plastic bag.
7.3 When you store the heater, let it cool down first, keep it dry. Then cover it with a plastic bag, put in a packing box and store it in a dry, ventilated
place.
8. Trouble shooting:
You can solve many common problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the
problem before calling the service center.
Problem
The heater does not operate,even
when
it is plugged in and
switch, thermostat are switched on .
The appliance didn't heat up, or only
ventilator worked
Abnormal noise
Disposal
Waste electrical production should not be disposed of with household waste. Please recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
Environmental Protection
Model identifier(s): 90-060
Item
Heat output
Nominal heat output
Minimum heat output
(indicative)
Maximum continuous heat
output
Auxiliary electricity consumption
Possible cause
The plug is loose, bad connection
the
No power in socket outlet
The switch was not put at heating setting
The thermostat operated
Manual reset cut-out operated
The appliance is not stands upright
Symbol
Value
Unit
Pnom
2.0
kW
Pmin
kW
1.1
Pmax
kW
2.0
Treatment
Pull out the plug, check the connection of the plug and
socket. Then connect again.
Insert the plug in a proper socket
Turn the switch to heat setting
Turn the thermostat and listen if there is open/close
voice. If there is no click and the thermostat is not
damaged, the heater will automatic switch on when
the appliance cooled down
Turn the heater off and inspect the blockage of inlet
or outlet. Disconnect the plug and wait at least 10
minutes for the protection system to reset before
attempting to restart the heater.
Put the heater on a level surface
Item
Type of heat input, for electric storage local space heaters only (select
one)
Manual heat charge control with integrated thermostat
Manual heat charge control with room and/or outdoor
temperature feedback
Electronic heat charge control with room and/or outdoor
temperature feedback
Fan assisted heat output
Unit
[yes]
[no]
[no]
[no]
Werbung
Inhaltsverzeichnis
