AEG AIK2404R Benutzerinformation Seite 16

16 www.aeg.com
Problem
Acoustic or visual alarm is
on.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the "Frostmatic", or
after changing the tempera‐
ture.
Door is misaligned or inter‐
feres with ventilation grill.
Door does not open easily.
The lamp does not work.
There is too much frost and
ice.
Possible cause
The cabinet has been re‐
cently switched on.
The temperature in the appli‐
ance is too high.
The door is left open.
Temperature is set incorrect‐
ly.
Many food products were
put in at the same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed cor‐
rectly.
The Frostmatic function is
switched on.
The compressor starts after
a period of time.
The appliance is not level‐
led.
You attempted to re-open
the door immediately after
closing.
The lamp is in stand-by
mode.
The lamp is defective.
The door is not closed cor‐
rectly.
The gasket is deformed or
dirty.
Solution
Refer to "Door Open Alarm"
or "High Temperature
Alarm".
Refer to "Door Open Alarm"
or "High Temperature
Alarm".
Close the door.
Refer to "Control Panel"
chapter.
Wait a few hours and then
check the temperature
again.
Refer to "Installation" chap‐
ter.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door"
section.
Refer to "Frostmatic func‐
tion" section.
This is normal, no error has
occurred.
Refer to installation instruc‐
tions.
Wait a few seconds between
closing and re-opening of
the door.
Close and open the door.
Contact the nearest Author‐
ized Service Centre.
Refer to "Closing the door"
section.
Refer to "Closing the door"
section.