WilTec Jebao XTP-Serie Bedienungsanleitung Seite 14

MAINTENANCE AND CLEANING (SEE FIG 2)
To clean the pump, remove the back cover and the impeller.
Use a small brush or stream of water to remove any debris
1. Follow these safety instructions. Make sure that the pump is unplugged.
2. Press the lower cover buckle(1) and separate the upper cover(4) and lower cover (3).show the
body pump (5) (see figure 3)
3. Screw out the Universal connector.(2)
4. Counterclockwise rotation loosening the Pump housing,
Remove the pump housing (6) from motor body (9).
5. Remove the rotor (7) from motor body(9).
6. Clean all parts using water and soft sponge.
Assembling the pump together:
 Place the rotor (7) in motor body (9) with caution.

Make sure the rotor is assembled correctly and will turn freely and check the position of the
sealing ring (8) on the pump body
 Put the pump housing (6) in the motor body (9)
 Place Body pump(5) and the upper cover (4) on the lower cover (3)(figure2). Make sure that
the buckle of the lower cover must lock the up cover (figure 2).
Overload protection
The pump has a built-in thermal overload trip which prevents the pump from overheating. The pump
must be allowed to cool down before restarting.
CAUTION: The pump shaft can not be removed.
IF THE PUMP FAILS TO OPERATE, CHECK THE FOLLOWING:
 Check the circuit breaker and try another outlet to ensure the pump is getting electrical power.
NOTE: Always disconnect from electrical outlet before handling the pump.

Check the pump discharge and tubing for kinks and obstructions. Algae build up can be flushed
out with a garden hose.

Check the inlet to ensure it is not clogged with debris.

Remove the pump inlet to access the impeller area. Turn the rotor to ensure it is not broken or
jammed.
 Monthly maintenance will add to your pump's life. NOTE: Ensure that the electrical cord loops
below the electrical outlet to form a "Drip Loop" This will prevent water from running down the
cord into the electrical outlet.
© by WilTec Wildanger Technik GmbH
http://www.wiltec.info
All manuals and user guides at all-guides.com
Seite 14