Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Safety guideline
BEWARE:
The use of this device is allowed on standing bodies of water, garden ponds' water or swimming
ponds and their surrounding areas only with fault current protection-switch with a triggering nominal
current up to 30mA (according to VDE 0100 Article 702 and 738).
The device is not suitable for use in swimming pools, paddling pools and other bodies of water in
which during operation people. The operation of the device during the stay of people in the danger
zone is not allowed. Ask your electrician.
The device is not intended for use by persons (including children) with impaired or limited physical,
sensory and mental abilities or lack of experience and/or real knowledge, unless they are supervised
by a person responsible for their safety or you follow the instructions made by this person how to use
the device correctly.
Children should be supervised to make sure that they do not play with the device.
ATTENTION:
Run a visual inspection of the device before every use. Do not use the device if the safety
appliances are damaged or worn out. Never override safety regulations.
Use the device exclusively according to the intended purpose stated in the instructions for
use.
You are responsible for the safety of the working environment.
If the cable or the plug is damaged due to external influences the cable must not be repaired!
It has to be replaced with a new one. This work can be carried out only by an electrician.
The voltage indicated on the type plate of the device of 230 Volt alternating voltage has to
correspond to the existent mains voltage.
Never lift, carry or fixate the device by using the power cable.
Make sure that the electrical plug connection is placed in a flood-proof area and is protected
from moisture.
Before working on the pond pump disconnect the appliance by taking the plug out of the
socket.
Avoid exposing the appliance to a direct water jet or rain.
The user is responsible for the compliance with location specific safety and installing
regulations. (Ask an electrician).
Consequential damage arising from flooded rooms caused by dysfunctions of the appliance
must be avoided by means of the appropriate measures. (installing an alarm system, reserve
pump).
In case of malfunction the repair work can be carried out only by a qualified electricial or the
WilTec-service.
The appliance must not run dry or with a completely closed intake port. The manufacturer's
guarantee is no longer valid if the damage is caused by dry running.
The appliance must not be used for swimming pools.
The device cannot be employed for potable water circuits.
© by WilTec Wildanger Technik GmbH
http://www.wiltec.info
All manuals and user guides at all-guides.com
Seite 12
Werbung
