Herunterladen Diese Seite drucken

WilTec Jebao XTP-Serie Bedienungsanleitung Seite 13

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

WARNING:
Read carefully all the safety guidelines and the instructions.
Non-compliance with the safety rules and regulations can lead to an electric shock, fire and/or serious
injury. Keep the instructions and the safety guidelines in a safe place in case you need them in the
future.
Stability
The max. temperature of the conveyed liquid should not exceed +35°C in permanent operation.
The conveyance of aggressive fluids (acids, bases, etc.) as well as of abrasive substances (for
example sand) must be avoided.
Electrical connection
The electrical connection takes place via an electric safety socket 230 V ~ 50 Hz. Fuse protection
at least 6 Amperes.
The engine is protected against overloading or blocking by means of a built-in motor protection. In
case of overheating the pump is turned off automatically due to the overheat protection and after
the cooling the pump is automatically started.
Power connection
The pond pump is equipped with a safety plug. The device is designed for connection to an isolated
ground receptacle with 230 V~50 Hz. Make sure that the socket outlet is sufficiently fused (at least 6A)
and safe. Insert the plug in the socket outlet and the pond pump is ready for use.
WARNING
This pump is supplied with a grounding conductor and a grounding type attachment plug. To
reduce risk of electric shock, connect only to a properly grounded outlet.
Do not remove the grounding pin from the plug.
Do not connect to any voltage other than that shown on the pump.
Do not pump flammable liquids.
A earth fault circuit interrupter be used in the branch circuit supplying fountain pumps and other
pond equipment. See your electrical supplies dealer for this device.
To reduce the risk of electrical shock, use only on portable
Warranty Information
Not covered by warranty:
Damaging the mechanical seal due to dry running or pumping cleaning agents or other chemical
substances.
Damages in transit
Damages caused by unauthorised interference
Parts subjects to wear (propeller, sealing flange) do not fall under warranty.
PERFORMANCE
A clogged or dirty intake screen will greatly reduce performance.
If the pump is used on a dirty surface, raise it slightly to reduce the amount of debris contacting the
intake.
Do not let the pump run when not submerged in water. Doing so may damage the pump. Always
submerge the pump first, and then plug in the electrical outlet. At the beginning, it probably can't pump
water, because there is air in the pump and the tube. Don't worry about it. Please pull out and insert
electrical outlet several times, it will work very well at once.
The pump is to be supplied through a residual current device (RCD) with a rated residual operating
current not exceeding 30mA.
© by WilTec Wildanger Technik GmbH
http://www.wiltec.info
All manuals and user guides at all-guides.com
Seite 13

Werbung

loading

Diese Anleitung auch für:

5038550386503878038850389