TFA 30.5021 Bedienungsanleitung Seite 8

TFA_No. 30.5021_Anleit_09_21
Digital thermo-hygrometer
5. Elements
Buttons
A: SET button
C: MAX/MIN button
Housing
D: Wall mounting hole
F: Battery compartment
6. Getting started
• Remove the stand by carefully pulling it downwards.
• Open the battery compartment by turning the lid with a coin counterclockwise. Remove
the insulation strip.
• Close the battery compartment again.
• All LCD segments will light up for about a few seconds.
• The unit is now ready to use.
• The upper display shows the time and the comfort level, the middle display shows the
current temperature and the lower display the relative humidity.
7. Setting of clock
• After battery was activated or press and hold SET button for 3 seconds, you will enter
the time setting mode.
• The hour digit is flashing.
• Press SWITCH button to adjust the hours.
• Press SET button again and set minutes in the same way.
• Hold and press the button for a fast count.
• Press SET button to confirm it.
14
10.09.2021 15:37 Uhr Seite 8
B: SWITCH button
E: Stand (removable)
Digital thermo-hygrometer
8. Temperature display
• Press SET button to change between °C (Celsius) or °F (Fahrenheit) as temperature unit
in normal mode.
• With Fahrenheit as temperature unit, the clock automatically switches to the 12 HR sys-
tem (PM appears on the display after noon).
9. MAX/MIN values
• Press MAX/MIN button.
• MAX appears on the display. The maximum temperature and humidity are displayed.
• Press the button again.
• MIN appears on the display. The minimum temperature and humidity are displayed.
• Press MAX/MIN button again to return to normal mode.
• Press SET button in the respective mode to clear the recorded MAX/MIN reading.
• --.- °C and --.- % appear on the display.
10. Comfort zone
• On the display appears a smiling face icon to indicate the comfort level of indoor climate
(humidity 40%...60%).
11. Display
• Using the SWITCH button, you can choose between the large-scale display of tempera-
ture or humidity in normal mode.
12. Positioning and mounting
• With the removable leg the instrument can be placed onto any flat surface or wall
mounted at the desired location by the wall mounting hole at the back of the unit.
15