About Installing The Outdoor Unit - Daikin EKLN140A1 Installationsanleitung

To install the support frame
1 Position the front support beam (a) and rear support beam (b)
parallel to one another with the open sections facing one
another.
2 Slide the upper support partition (c) and lower support partition
(d) between the 2 support beams.
3 Check that all holes in the support bars and partitions are
aligned with one another.
4 Connect the vibration dampers (accessory V) to the support
beams and partitions using the M8 spring washers (accessory
H) and M8 nuts (accessory I).
5 Connect the support beams and partitions to one another using
the M5 Torx screws (accessory A) and washers (accessory B).
INFORMATION
Tighten them hand-tight (tightening torque <5N∙m).
6 Affix 1 strip of sealing tape (accessory C) to both support
beams in the centre of the front support beam profile (a) and
rear support beam profile (b).
a
a Sealing tape (accessory C)
7 (Optional) If you use the support frame as the base of the drain
pan: cut the U-shaped finishing rubber (accessory L) into 4
equal parts of 3 cm long and place them on the top ends of both
intermediate support partitions on the upper part.
L
L
8 Fit the front of the foremost support beam with rounded rubber
(accessory Q).
9 Cut the correct lengths and ensure that the rubber is interrupted
at the notches.
10 Click the support frame into the base frame using the grooves.
EKLN140A1
Low sound enclosure
4P650154-1A – 2021.04
Result:
L
L
4.2.3
a
a Location of groove in base frame
a Location of groove in support frame
11 Fix the foremost support beam to the floor using the lag screws
(accessory E), sheet metal washers (accessory F), and plugs
(accessory D) if working with a stony base.

About installing the outdoor unit

INFORMATION
For details about installation of the outdoor unit, see the
manual of the outdoor unit.
CAUTION
When installing the low sound enclosure on an existing
outdoor unit, the wiring and refrigerant piping MUST go
through 1 of the 3 premounted openings in the base frame
of the low sound enclosure.
ALWAYS follow the instructions in the installation manual
and service manual of the outdoor unit for the related
procedures to uninstall and reinstall the outdoor unit.
4 Unit installation
a
Installation manual
5