About The Unit And Options; Possible Combinations; Possible Options; Unit Installation - Daikin EKLN140A1 Installationsanleitung

(a)
Accessories Illustration
F
G
H
I
J
K
L
M
N
O
P
Q
R
EKLN140A1
Low sound enclosure
4P650154-1A – 2021.04
Description Accessories
Sheet metal washer S
M6×20
Round spacer cap
T
Spring washer M8
U
Nut M8
V
Sheet metal washer
M8×30
Rounded finishing
profile, small
3
3.1
See the data book of the outdoor unit to check if the low sound
enclosure is compatible with the outdoor unit.
U-shaped finishing
profile
3.2
Drain pan and heater tape
To evacuate drain water, use:
Guide pin Ø8×25 M5
▪ Drain pan (EKLN140-DP)
To keep the drain holes free in cold climates, also use:
Spacer bush 15×2.5
▪ Heater tape (EKLN140-DPHT)
Spacer bush 12×7
4
D-rubber sponge,
self-adhesive
Rounded finishing
profile, big (1 m)
Key

3 About the unit and options

(a)
Illustration
(a)
This manual refers to each accessory with a specific letter from A
to V.
About the unit and options

Possible combinations

Possible options

Unit installation

WARNING
Installation shall be done by an installer, the choice of
materials and installation shall comply with the applicable
legislation. In Europe, EN378 is the applicable standard.
WARNING
Installation MUST be carried out by an authorised installer.
2 people are required to install the low sound enclosure.
WARNING
The parts may have sharp edges. Wear cut-resistant work
gloves during installation.
Description
Base frame corner
bracket
Base frame sealing
pad
Base frame sealing
pad
Vibration damper
Installation manual
3