Overmax Multipic 4.1 Bedienungsanleitung Seite 22

How to connect to external disk (see: fig. 10)
To play multimedia from a pendrive or external disk, you need to do the
following:
a.
Insert the disk in USB-A port at the back of the casing.
EN
b.
Use direction keys on the remote control to select (Media) and confirm
by pressing (OK) on the remote control.
How to connect video to mobile devices remotely
The projector is equipped with a wireless Wi-Fi connection module which allows
displaying the image from a mobile device wirelessly. Only mobile devices
compatible with MIRACAST technology can transmit image to the projector.
To start a wireless video transmission to the projector, please follow the
steps below:
a.
Use direction keys on the remote control to select (Miracast) if you use
the device with Android system compatible with Miracast. If you use
Apple device with iOS system, select (iOS Cast). After selecting, confirm
with (OK) key on the remote control.
b.
Activate Wi-Fi module in the mobile device.
c.
Depending on the device, connecting through „Miracast" may vary.
Android devices: find settings described as Miracast, next screen duplication
or screen connection. Next enable searching for active wireless screens. Then
find the device called „ZYCast" and connect to it.
Apple devices with iOS system: Make sure the projector and device from which
you wish to broadcast the image is connected to the same Wi-Fi network.
Enter the control panel and select screen duplication, next find the device
named „ZYCast" and connect to it.
In case of any connection issues, return to Wi-Fi network connection setup.
Select (AUTO-IP) and confirm. Next go back to the connection screen (iOS
Cast) and retake steps in the phone.
Advanced playing settings in iOS mode
a.
Use direction keys on the remote control to select (Settings) and confirm
with (OK) key.
b.
Go to (Advanced) and confirm your choice with (OK) key.
c.
Select (iOS Play Mode), and then select image duplication or screen shot.