Using The Appliance - Philips Aqua Plus 8000-Serie Bedienungsanleitung

English
8
- Do not clean the metal wetting strip with a sharp object, as this may damage the strip. Only clean
the wetting strip by rinsing it under the tap. Replace the wetting strip when you can no longer clean
it.
- Replace the wetting strip only with an original strip.
- To guarantee good cleaning results and proper functioning of the appliance and water tank, always
use original Philips cleaning pads.
- Clean the water tank according to the instructions. The water tank is not dishwasher-proof.
- Do not use aggressive cleaning agents or tools to clean the Aqua Boost pedal (Fig. 4).
- After mopping the floors, do not store the appliance with the water tank attached on the charging
station. If you do this, the wet mopping pad will touch the wall and this may damage the wall.
Always remove the water tank before you store the appliance.
Electromagnetic fields (EMF)
This Philips appliance complies with all applicable standards and regulations regarding exposure to
electromagnetic fields.

Using the appliance

Usage restrictions
- Only use the water tank on hard floors with a water-resistant top coat (such as linoleum, enameled
tiles and varnished parquet) and stone floors (such as marble). If your floor has not been treated to
make it water-resistant, check with the manufacturer if you can use water to clean it. Do not use
the water tank on hard floors of which the water-resistant top coat is damaged.
- Only use the water tank on linoleum floors that are properly affixed to prevent linoleum from being
drawn into the mopping nozzle.
- Do not use the water tank to clean carpets.
- Do not move the appliance with water tank assembled sideways, as this leaves water traces. Only
move forwards and backwards.
Note: The operating time depends on the power level used during cleaning.
Mopping pad and wetting strip
The appliance comes with one wetting strip and two identical microfiber mopping pads. With the
water tank, wetting strip and microfiber mopping pad attached to the standard floor nozzle, you can
clean hard floors.
Using liquid floor cleaner in the water tank
If you want to add a liquid floor cleaner to the water in the water tank, make sure that you use a low-
foaming or non-foaming liquid floor cleaner that can be diluted in water. As the water tank has a
capacity of 200ml, you only have to add a few drops of liquid floor cleaner to the water.
Cleaning the water tank
To clean the water tank, mix one part vinegar with three parts water. Pour this mixture into the water
tank and close the cap. Shake the water tank and put the water tank on a water-resistant surface.
Leave the water-vinegar mixture in the water tank overnight. Then empty the water tank, rinse it
thoroughly with fresh water, and use it normally again.