Reich MOVE CONTROL ECONOMY LIGHT Montageanweisung Und Bedienungsanleitung Seite 27

All manuals and user guides at all-guides.com
Appendix A2 - A4
A2 Maintenance
•
Have your MoveControl maintained and visually
inspected once a year :
- Clean the entire manoeuvring drive.
- Provide all moving joints and parts with appro-
priate, acid-free lubricant, e.g. silicon spray
- Check the distance of the drive rollers to the
tyres and the tyre pressure.
- Visual inspection of the cabling and the electri-
cal connection for loose connections and dam-
age.
- Check the battery voltage.
•
Check before each drive whether the manoeu-
vring drive is free of dirt, sand and branches.
•
Contact your dealer in the event of faults.
A3 Comments and hints
•
You can use the MoveControl to couple it to
your towing vehicle at any time.
•
Ensure that both drive units are uncoupled
before driving off with your towing vehicle
(Figure 3.4 = OFF).
•
Use wedges in front of curbs or similar obsta-
cles.
•
Store the remote control and the documentation
in a dry place.
•
The MoveControl is equipped with electrical
overload protection and automatically switches
off when it is overloaded.
• Synchronisation must be performed when the
remote control or the base station is replaced
(Appendix A1).
•
Replace the batteries in your remote control as
required (Figure 2.2).
A4 FAQ's
•
The MoveControl cannot be mounted on the
chassis.
- The MoveControl series was designed for
attachment to a standard chassis. Additional
adapters are available on request.
• The spare wheel obstructs the installation of the
MoveControl.
- Move the spare wheel carrier by using an
adapter.
•
The MoveControl twists very strongly.
- An extended stabilising rod is to be used when
the current one does not extend at least 300
mm into the respective frame.
- Take note of the minimum frame strength (see
Figure 8.1, Dimension C ). An optional frame
reinforcement must be installed as required.
•
The MoveControl cannot be switched on by
remote control.
- The main switch is not switched on.
- The remote control is not synchronised with
the base station.
- The voltage supply is too low .
• The drive roller slips on the tyre.
- The distance between drive roller and tyre has
been de-adjusted. The distance must be 15-20
mm.
- Check the tyre pressure and increase as re-
quired.
- The MoveControl twists very strongly (see
above)
•
The vehicle jerks during manoeuvring.
- The supply voltage or the battery capacity is
too low. The minimum capacity of the battery
should be 50 Ah for a single axle and 75 Ah for
tandem trailers.
- The battery of the remote control has failed,
replace battery.
- Extend the antenna from the housing lid.
- Antenna signal interference due to shielding or
magnetic fields. Extend the antenna cable verti-
cally from the housing lid. Ensure that the cable
is not in contact with metal parts. Open any
aluminium-coated window shutters
•
The easy driver moves exactly in the opposite
direction shown by the icons on the remote
control.
- The electronic system is not connected accord-
ing to the connection plan
• The MoveControl pulls towards one side during
manoeuvring.
- The cables to the drive motors have different
lengths.
- The drive rollers and tyres are not arranged in
parallel.
- The tyre pressure or the weight distribution is
different
GB9