yeedi K651G Bedienungsanleitung Seite 26

No. Scenario
Robot cannot return to
3
the Docking Station.
Robot misses cleaning
spots to be cleaned,
4
or repeats cleaning the
area cleaned.
Robot gets stuck while
5
working and stops.
Robot is making too
6 much noise when
cleaning.
EN 26
Possible Cause
The Docking Station is not correctly placed.
The Docking Station is not correctly connected.
The Docking Station is manually moved during the
cleaning.
Robot did not start cleaning from the Docking
Station.
The cleaning cycle is interfered by small objects or
barriers on the floor.
Robot is working on slippery polished floors.
Robot is unable to reach certain areas blocked by
furniture or barriers.
Robot gets stuck while working and stops.
Robot might be stuck under furniture with an
entrance of similar height.
Robot is tangled or blocked with debris.
Solution
Refer to Section 3.2 correctly place the Docking
Station.
Make sure the Docking Station is correctly connected.
It is suggested not to move the Docking Station during
the cleaning.
Make sure Robot starts cleaning from the Docking
Station.
Remove power cords and small objects from the floor
to ensure cleaning efficiency. Robot will automatically
clean the area missed, please avoid moving Robot
manually or block the path during the cleaning cycle.
Make sure the floor wax is dried before Robot starts
cleaning.
Tidy up the area to be cleaned by putting furniture and
small objects in their proper place.
Robot will try various ways to free itself. If it is
unsuccessful, manually remove the obstacles and
restart.
Please set a physical barrier.
Clean Robot as described in section Maintenance and
restart. If the trouble persists, please contact Customer
Care.