Installation; Start-Up And Use - Indesit RG 2330 Gebrauchsanleitung

Installation

GB
! Before placing your new appliance into operation
please read these operating instructions carefully. They
contain important information for safe use, for installation
and for care of the appliance.
! Please keep these operating instructions for future
reference. Pass them on to possible new owners of the
appliance.
Positioning and connection
Positioning
1. Place the appliance in a well-ventilated humidity-
free room.
2. Do not obstruct the rear fan grills. The compressor
and condenser give off heat and require good
ventilation to operate correctly and save energy.
3. Leave a space of at least 10 cm between the top
part of the appliance and any furniture above it, and
at least 5 cm between the sides and any furniture/
side walls.
4. Ensure the appliance is away from any sources of
heat (direct sunlight, electric stove, etc.).
5. In order to maintain the correct distance between
the appliance and the wall behind it, fit the spacers
supplied in the installation kit, following the
instructions provided.
Levelling
1. Install the appliance on a level and rigid floor.
2. If the floor is not perfectly horizontal, adjust the
refrigerator by tightening or loosening the rear feet.
Electrical connections
After the appliance has been transported, carefully place
it vertically and wait at least 3 hours before connecting it
to the electricity mains. Before inserting the plug into the
electrical socket ensure the following:
• The appliance is earthed and the plug is compliant
with the law.
• The socket can withstand the maximum power of the appliance,
which is indicated on the data plate located inside the freezer
(e.g. 150 W).
• The voltage is in the range of values indicated on the data plate
located inside the freezer (e.g. 220-240V).
• The socket is compatible with the plug of the
appliance. If the socket is incompatible with the plug,
ask an authorised technician to replace it ( see
Assistance ). Do not use extension cords or multiple
sockets.
! Once the appliance has been installed, the power
supply cable and the electrical socket must be easily
accessible.
! The cable must not be bent or compressed.
! The cable must be checked regularly and replaced by
authorised technicians only (see Assistance).
! The manufacturer declines any liability should
these safety measures not be observed.
8

Start-up and use

Starting the appliance
! Before starting the appliance, follow the installation
instructions ( see Installation ).
! Before connecting the appliance, clean the compartments and
accessories well with lukewarm water and bicarbonate.
! The appliance comes with a motor protection control system
which makes the compressor start approximately 8 minutes after
being switched on. The compressor also starts each time the
power supply is cut off whether voluntarily or involuntarily
(blackout).
1. Insert the plug into the socket and make sure that the green
POWER indicator light illuminates (the TEMPERATURE
ADJUSTMENT knob must be in the OFF position).
2. Turn the TEMPERATURE ADJUSTMENT knob to an average
value and press the SUPER FREEZE button (rapid freezing):
the SUPER FREEZE indicator light
off once the freezer has reached its optimal temperature. At this
point food may be placed inside the appliance.
Using the freezer to its full potential
•
Use the TEMPERATURE CONTROL knob to adjust the
temperature.
MIN = warmest
MAX = coldest
is the optimal temperature for energy saving levels.
We recommend, however, a medium position.
• Do not re-freeze food that is defrosting or that has already
been defrosted. These foods must be cooked and eaten
(within 24 hours).
• Fresh food that needs to be frozen must not come into contact
with food that has already been defrosted. Fresh food must be
stored in the top FREEZER and STORAGE compartment.
• Do not place glass bottles which contain liquids, and which are
corked or hermetically sealed in the freezer because they
could break.
• The maximum quantity of food that may be frozen daily is
indicated on the plate containing the technical properties located
within the freezer (for example: Kg/24h: 4).
• To freeze (if the freezer is already operating):
- for small quantities which are less than those indicated on the
data plate, press the rapid freezing SUPER FREEZE button
(corresponding indicator light
and close the door. The function is disabled automatically after
24 hours or when optimal temperatures have been reached
(indicator light goes out);
- for large quantities which are greater than the maximum load
indicated on the data plate, hold down the rapid freezing SUPER
FREEZE button until the corresponding indicator light begins to
flash. After 24 hours the indicator light stops flashing and remains
on constantly. Place the food inside the freezer and close the
door. After another 24 hours, the function will be disabled
automatically (indicator light goes out).
! Do not open the door during freezing.
will illuminate. It will switch
illuminates), insert the food