General Information; Appliance Description - STIEBEL ELTRON WK 2 Installationsanleitung

INSTALLATION

General information

1. General information
Note
Read these instructions carefully before using the ap-
pliance and retain them for future reference.
Pass on the instructions to a new user if required.
1.1 Relevant documents
Operating and installation instructions for the out-
door unit
Note
Please see appliance operating and installation in-
structions for information on the "Guarantee" and
"Environment and recycling".
1.2 Units of measurement
Note
All measurements are given in mm unless stated oth-
erwise.

2. Appliance description

Dimensions
60 8
4 |
968
490
Construction
1
1 Wall mounting bracket
2 Rubber buffer
3 End cap
4 Retaining clip
5 Washer
6 Hexagon screw
2.1 Standard delivery
2x Wall mounting bracket
4x Hexagon screw M8 x 75
4x Retaining clip M10
4x Rubber buffer M8
2x End cap
4x Washer 8.4 x 30 x 2
3. Preparation
Material losses
!
Note the maximum load bearing capacity of the sup-
port (see chapter "Specification / Data table").
f Ensure that the wall is able to bear the weight of the out-
f
door unit plus wall mounting bracket.
Note
If you are unsure about the load bearing capacity of
the wall, please consult a structural engineer.
Material losses
!
If the load bearing capacity of the wall cannot be guar-
anteed, do not use the wall mounting bracket.
f Select suitable screws and rawl plugs to secure the wall f
mounting bracket on the wall.
Material losses
!
For the following installation steps observe the re-
quired clearance dimensions.
For information, see the operating and installation in-
structions of the outdoor unit (chapter "Dimensions
and connections").
2
3
4
5
6
WK 2