FLSUN SR Benutzerhandbuch Seite 3

Advice and Guidance
The printer's default power input voltage is 230V, if your local voltage is 115V,
•
please switch the input voltage of the power supply before turning on the printer
for the first time.
The assembly videos, firmware and slicing software are included in the SD card,
•
please back up the files of the SD card to your computer before using.
Do not touch the hot bed and nozzle while the printer is running, as the heat
•
would cause the burn injuries to your skin.
The printer's environment can affect the print quality, please ensure the printer is
•
not placed in too hot/cold temperature, high humidity or near drafts. To ensure
optimum printing, place the printer on an even and firm surface.
Failures caused by changes to the printers mechanical components are not
•
covered by the printers warranty.
Keep young children away from the printer due to the hot components while
•
printer is running.
Please use the recommended filaments, poor quality filaments may cause poor
•
print quality or damage the printer.
Typical maintenance would be useful.
•
Please wait for the hot bed to cool down completely before removing the print.
•
In case of emergency, turn off the printer and pull it from the main power to
•
prevent damage to the printer then contact our technical support.
To avoid damage to printer and property, do not misuse printer. Printer has been
•
designed for it's intended purpose only.
All printers have been tested before leaving the factory. As a result of these tests,
•
some filament and stain might remain in and around nozzle, this is normal.
In order to make the model stick to the hot bed well, please clean the hot bed
•
before each print.
• When the printer has to be restored to factory settings, please restart the printer
first, and then click "Restore".