Hazet-Werk 4934-2585/12 Betriebsanleitung Seite 21

All manuals and user guides at all-guides.com
Assembling the wheel hub bearing
3
4930-2
• Put the 5 thrust pins F into the receiving holes of the thrust plate E.
• Insert the thrust ring halves A laterally between the rear side of the wheel hub flange and the
circlip and tighten firmly with the 2 cylinder head screws M8 x 35.
• Put the threaded spindle 4930-1 with the thrust plate E and the 5 inserted thrust pins F from out-
side onto the wheel hub bearing that the thrust pins F protrude the threaded holes of the wheel
hub and are supported at the front side of the thrust ring A.
4
• Put the thrust plate c onto the spindle nut 4930-2.
• Put the wheel hub bearing with the attached thrust plate E and the spindle 4930-1 from outside
into the bearing housing. At the same time insert the thrust washer c with the spindle nut 4930-
2 into the interior of the bearing housing (axle body) and then screw in the spindle nut 4930-2.
• Before the new wheel hub bearing is assembled, it has to be ensured that it is axially parallel
and centric to the receiving hole of the bearing housing (axle body).
During operation do not reach into extractor device!
Lubricate the threaded spindle 4930-1 before each use!
Design and Function
3
Bearing housing / Axle body
A
c
Cylinder head
screw
M8 x 35
F
4930-1
E
21