Set 12/24 Hour - Audizio Metz Compact Stereo Bedienungsanleitung

SET TIME
Use the < TUNE/ TUNE > buttons on the remote or [ ] or [ ]-buttons on the micro system to adjust the digits and the ENTER
button on the remote or UNPAIR/ENTER on the micro system to skip to the next setting.
Use the same buttons from step 1 (above) to set the time and then the date.
Press the ENTER button on the remote or UNPAIR/ENTER on the micro system when complete to store the settings.
AUTO UPDATE
This setting specifies the automatic clock setting.
Use the < TUNE/ TUNE > buttons on the remote or [ ] or [ ]-buttons on the micro system to select from- ANY (sets the clock
from any mode possible), DAB (sets the clock only from DAB mode), FM (sets the clock only from FM mode), NONE (does not
set the clock automatically and uses the manual time as described above)
Press the ENTER button on the remote or UNPAIR/ENTER on the micro system to store the setting .

SET 12/24 HOUR

Select how the clock is displayed.
Use the < TUNE/ TUNE > buttons on the remote or[ ] or [ ]-buttons on the micro system to select from 12 or 24 hours.
Press the ENTER button on the remote or UNPAIR/ENTER on the micro system to store the setting .
SET DATE FORMAT
Select how the date is displayed.
Use the < TUNE/ TUNE > buttons on the remote or[ ] or [ ] buttons on the micro system to select from- DD-MM-YYYY (Day,
Month & Year), MM-DD-YYYY (Month, Day & Year)
Press the ENTER button on the remote or UNPAIR/ENTER on the micro system to store the setting .
Follow the below instructions to switch between CD, DAB, FM, AUX IN, USB &
BLUETOOTH input modes.
Press the SOURCE button on the micro system or remote control repeatedly to cycle between CD, FM, AUDIO-IN &
BLUETOOTH input modes.
Press the relevant button on the remote to select the input mode you require. Press the FM/DAB button to switch to DAB
mode . Press once more to switch to FM mode.
Before switching to the DAB input mode (refer to page 20) the antenna needs to be extended fully to allow stations to be
located during the initial scan.
When the DAB mode is activated for the first time the unit will perform a scan for available stations. You will see SCANNING..
0 appear on the display until stations are located and then the O will change to the amount of stations found.
When located the first alphanumerical station will begin playback while the other stations are stored.
lf no stations where located during the scan, relocate the unit, extend the antenna fully and read the Performing a DAB
station scan section.
Listening to the stored DAB stations
To listen the DAB stations that have been stored press the [ ] or [ ] buttons on the micro system or < TUNE or TUNE > buttons
on the remote control.
Press the UNPAIR/ENTER button on the micro system or ENTER on the remote to switch to the selected station.
Performing a DAB station scan
Should you need to perform a fresh station scan for example you relocate the unit or a new station comes online follow the
below steps.
Ouick scan searches all DAB channels .
To activate the quick scan press the SCAN button on the micro system or remote controL
To activate the full scan press the MENU button on the remote or press and hold the MENU/INFO button on the micro system.
When the FULL SCAN option appears press the ENTER button on the remote or UNPAIR/E NTER on the micro system to
perform a full scan.
Manual DAB tuning
8