Audizio Metz Compact Stereo Bedienungsanleitung Seite 10

Press the TREBLE button again to edit the BASS level using the VOLUME+/- buttons to adjust the level.
X-Bass function
Enabling the X-Bass function adds more emphasis to the bass output
Press the X-BASS button on the remote control to enable the function.
Press the X-BASS button once more to disable the function.
EQ function
Enabling the EO function applies various equaliser presets to the sound output to better match the style of audio you are
listening to.
Press the EO button on the remote control repeatedly to cycle through the EO sound effects. Select from FLAT, ROCK,
CLASSIC, POP, VOCAL & JAZZ.
Sleep timer
Enabling the sleep timer will shut down the micro system into standby mode when the preset time expires.
Press the SLEEP button on the remote control repeatedly to cycle between 90-10 minutes sleep timer. The next press after 10
minutes will turn the sleep timer off.
When the unit is standby mode the backlight will dim after 10 seconds. Press the LIGHT button on the remote control to
illumina te the backlight for 10 seconds.
Stereo/ Mono mode
Sometimes Stereo radio stations can suffer from interference (statie & crackles) to reduce this problem you can enable
MONO mode.
Press the MONO/ST button on the remote control to switch between STEREO & MONO modes.
FM display modes
Every time you press the INFO button on the remote control, the display will cycle through the following display modes.
Radio text: Broadcasters can include a scrolling text that displays information about the current program lf radio text is not
available then the display will show NO TEXT
Program type: This describes the Style or genre of music that is being broadcast
e.g. Rock or Classical
Program name: Displays the name of the current station.
Audio mode : Displays the current FM mode of STEREO or MONO.
Time & date: The time & date is set automatically from the DAB or FM broadcast.
Tuning an FM station
To scan for radio stations press and hold either of the < TUNE or TUNE > buttons on the remote or[ ] or [ ] buttons on the micro
system for two seconds to scan down or up the frequency band. When a station is found the scan will stop and the station will
begin to play. (Fig 13)
To fine tune the frequency press either of the < TUNE or TUNE > buttons on the remote or [ ] or [ ] buttons on the micro
system (do not press & hold ), to jump 0.05 MHz up or down.
Alternatively press the SCAN button on the remote to begin scanning up the frequency range. When a station is located
playback will begin automatica lly.
FM scan modes
Scan modes determine how strong an FM signa! needs to be to be accepted as a potential radio station when scanning.
Press the MENU button on the remote or press and hold the MENU/INFO button on the micro system
When the SCAN SETTING option appears press the ENTER button on the remote or UNPAIR/ENTER on the micro system
Use the < TUNE or TUNE > buttons on the remote or / buttons on the micro system to select between STRONG
STATIONS (Strong local stations only) or ALL STATIONS (All available stations)
Press ENTER button on the remote or UNPAIR/ENTER on the micro system to save
Storing station presets
Follow the below steps to store a tuned station to one of 10 preset locations to allow quick access.
Tune to the station you wish to store as a preset and follow the below instructions.
Press and hold the MEMORY button on the remote control. The display will show
l EMPTY, where 1 is the selected preset location . (Fig 14)
10