Herunterladen Diese Seite drucken

CALOR DT81-Serie Bedienungsanleitung Seite 4

Werbung

• To protect against a risk of electric shock, do not immerse the
appliance in water or other liquids.
• Do not direct steam at people, animals or clothes while they are being
worn.
• This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible
for their safety. Children should be supervised to ensure that they do
not play with the appliance.
• The use of accessory attachments other than those provided by the
manufacturer is not recommended and may result in fire, electric
shock or personal injury.
• The appliance must be used and placed on a flat, stable, heat-resistant
surface. When you place the iron on the iron rest, make sure that the
surface on which you place it is stable.
• The appliance must not be used if it has been dropped, if it has any
visible damage, if it leaks or if it functions abnormally in any way. Do
not attempt to dismantle your appliance : have it examined at an
approved service centre to avoid any danger.
• Check the electrical power cord for sign of wear or damage prior to
use. If the electrical power cord is damaged, it must be replaced at an
approved service centre to avoid any danger.
• Do not use other descaling products than the one cited in the IFU.
• To achieve optimal results in sanitizing , gently steam back and forth
3 times on the fabric.
Before first use
• When you first use the appliance, some smoke or a harmless odour may be produced or there may be a small
discharge of particles. This will not affect the use of the appliance and will disappear quickly.
What water to use?
• Your appliance has been designed to use untreated tap water.
Do not use pure demineralised or pure distilled water, water from clothes dryers, scented or softened water, rain water,
filtered, bottled or boiled water, water from refrigerators, batteries or air conditioners as these may damage the appliance.
These types of water contain organic waste, mineral elements that become concentrated when heated and cause spitting,
brown staining, leaking or premature wear on your appliance. If your water is very hard, mix 50% untreated tap water
with 50% distilled water (available in hardware stores). This water contains organic waste materials or minerals that
concentrate under the effect of heat and cause spitting, brown colouring or premature ageing of your appliance.
6
SAVE THESE INSTRUCTIONS
Environment protection first !
Your appliance contains valuable materials which can be recovered or recycled.
i
Leave it at a local civic waste collection point.
Problems with your garment steamer?
PROBLEM
POSSIBLE CAUSES
There is no steam.
The appliance is not plugged in, or not
switched on.
The water level is too low.
The steam pump has not been primed.
You are using the appliance for the first
time.
The water tank is not fully in place.
The appliance is on stand by mode* or
auto-off*.
The appliance does not
It is not plugged in, or not switched on.
heat.
The appliance is on stand by mode* or
auto-off*.
The water tank is not fully in place or the
stopper is not closed properly.
Water leaks.
Boost mode has been used too often
(more than 3 times a minute)
Scale has built up in the appliance
Steam rate decreases.
The steam leaves stains
You are using water with additives.
on the fabric or the
appliance spits.
The appliance has not been cleaned
enough after the descaling operation.
You are using other liquids than white
vinegar to descale the product.
Appliance steams
The steam trigger is on the lock position.
continuously.
Micro-fiber brush* support
is removed from the
steam head. Micro-
You scrub too tightly the textile.
fiber* is removed from
the micro-fiber brush*
support.
* EN Depending on model
SOLUTIONS
Check that your appliance is correctly
plugged in and switched on.
Unplug your appliance and refill it.
Press the steam trigger continuously
for a few seconds to begin steaming.
Press the steam trigger continuously
for a few seconds to begin steaming.
Ensure that stopper is closed and
that the water tank snaps when put
into place.
PLEASE REFER TO THE 'STANDBY/
AUTO-OFF' section.
Plug in your appliance and switch on.
PLEASE REFER TO THE 'STANDBY/
AUTO-OFF' section.
Ensure that stopper is closed and
that the water tank snaps when put
into place.
Avoid using the boost more than 3
times a minute.
Refer to 'EASY DESCALING' section in
instructions for use.
Never add any additive in the water
tank.
Read carefully the 'EASY DESCALING'
section in instructions for use.
Use only white vinegar during 'EASY
DESCALING' procedure.
Unlock the steam trigger.
Scrub softly the textile to remove
impregnated dust.
7

Werbung

loading

Diese Anleitung auch für:

Dt82-serieDt8171c0 access steam+ 1600