Technoline WS 6440 Bedienungsanleitung Seite 15

Step 2:
Keep your weather station and wireless outdoor transmitter next to each other. Slide open the battery cover
at the back of your wireless outdoor transmitter, then insert 2 x AAA alkaline batteries to the battery
compartment. Make sure the Channel selector is at 1 position. Replace the battery cover.
(Channel 1) is displayed under the outdoor temperature and humidity. You could press  /
Make sure
CHANNEL to select Channel 1.
Your weather station will receive data signal from the outdoor transmitter in few seconds. Then place your
outdoor transmitter in a dry and shaded area.
Installing backup batteries
Your weather station requires 3 "AAA" alkaline batteries to provide backup power to it in the event of a
temporary power interruption.
1. Place your weather station face down on a flat surface.
2. Slide and remove the battery cover at the bottom of your weather station.
Insert 3 "AAA" alkaline batteries into the battery compartment by observing the "+" and "-" polarity as
3.
indicated.
4. Replace the battery cover.
If the AC main power is interrupted, the backlight will go off. The backup batteries will keep the time and all
settings of your weather station. Press
Remarks:
Keep in mind that your outdoor transmitter has a 30-meter open air transmission with no obstructions.
Actual transmission range will vary depending on what is in the path of the signal. Each obstruction (roof,
walls, floors, ceilings, thick trees, etc.) will effectively cut signal range in half.
Insert the holder to the bottom of the outdoor transmitter for desktop or insert it to the back of the
transmitter for wall mount purpose.
DCF SIGNAL RECEPTION AND SIGNAL INDICATOR
After your weather station is powered up, it starts to receive DCF signal. The
Weak or no DCF signal
once to turn on the backlight for 5 seconds.
(only icon flashing)
EN. 4
icon flashes.