After Ironing - Bosch Sensixx'x DA70 Gebrauchsanleitung

The descaling liquid can be obtained from our
after-sales service or specialist shops :
Accessory code
(After-sales)
311144
10
Drip protection
lf the temperature is set too low, the steam is
automatically switched off to avoid dripping.
There may be an audible click when this occurs.
Fabric-protection
11
soleplate cover
(Model dependent)
The fabric-protection is used for steam-ironing
delicate garments at maximum temperature
without damaging them.
Use of the protector also does away with the need
for a cloth to prevent shine on dark materials.
It is advisable to irst iron a small section on the
inside of the garment to see if it is suitable.
To attach the fabric protector to the iron, place
the tip of the iron into the end of the fabric
protector and press the rear of the protector
upward until you hear a click. To release the
fabric protector, pull down on the clip at the rear
and remove the iron.
The fabric-protection soleplate cover may be
purchased from the customer service or specialist
shops :
Accessory code
(After-sales)
575494
12
StoreProtect
(Model dependent)
1. D o not use the protector during ironing or
when the iron is connected to the mains!
Unplug the iron from the mains socket, empty
the water tank, set the steam regulator to
the position and put the iron into the store
protector.
2. D o not touch the store protector when the iron
is attached, as it could get hot.
All manuals and user guides at all-guides.com
3. N ever rest the iron on the protector out of the
4. T he protector can be used on a horizontal and
Name of accessory
(specialist shops)
TDZ1101
• Switch the steam regulator from
• Empty the tank.
• Hold the iron with the point down and shake
• Store standing on the rear, not on the base.
• Do not wrap the power cord too tight!
Name of accessory Always unplug the appliance from the mains
(Specialist outlets)
supply before carrying out any cleaning or
maintenance operation on it.
TDZ1550
• If the iron is only slightly soiled, pull out the
• If the cloth is synthetic, it may melt due to
• To keep the soleplate smooth, you should
• Never decalcify the tank or treat it with
rubber pads when the soleplate is still hot.
stable surface, or in a vertical position ixed to
a wall by means of two bolts (one at the tip and
another one at the rear).
The power cable may be coiled loosely around
the heel of the iron.
To attach the store protector to the iron, place
the tip of the iron into the front rubber pad of the
protector and press the rear of the iron until you
hear a click.
To release the store protector, pull down on the
clip at the rear and remove the iron.
Accessory code Name of accessory
(After-sales)
575960
13
After ironing
and back again several times (self- cleaning).
lightly.
14
Cleaning
Attention ! Risk of burns !
plug and allow the soleplate to cool down. Wipe
the housing and the soleplate with a damp
cotton cloth only.
thehigh temperature on the soleplate, switch off
the steam and rub off any residue immediately
with a thickly folded, dry cotton cloth.
avoid hard contact with metal objects. Never
use a scouring pad, or chemicals to clean the
soleplate.
detergents or solvents, otherwise the iron will
drip water whilst steaming.
(Specialist outlets)
TDZ1750
to "max"
17
BOSCH