Ironing With Steam; Shot Of Steam; Vertical Steam - Bosch Sensixx'x DA70 Gebrauchsanleitung

5
Ironing with steam
Temperature
setting
●●
●●● to max
i-Temp*
AntiShine*
* model dependent
Tip: for better ironing results, iron the last strokes
without steam to dry the garment.
6
Spray
Do not use the spray function with silk.
7
Shot of steam
• Set temperature to "max".
• Press button repeatedly with intervals of at
least 5 seconds.
8
Vertical steam
Never direct the steam jet at garments that
are being worn.
Never aim the steam at people or animals.
• Set temperature to "max".
• Hang article of clothing on a clothes hanger.
• Operate the iron in a vertical position at a
distance of 10 cm / 4 in, and press the
button repeatedly with pauses of at least 5
seconds.
16
All manuals and user guides at all-guides.com
This range is equipped with the following
Recomended steam
anti-calc systems "3AntiCalc" (components
regulator setting
1+2+3)
1 or 2 / eco*
1. self-clean
1 to "max"
Each time you use the steam regulator, the
1 to "max"
"self-clean" system cleans the mechanism of
scale deposits.
1 or 2 / eco*
2. Calc'nClean
The "Calc'nClean" function helps to remove scale
particles out of the steam chamber. Use this
function approximately every 2 weeks, if the
water in your area is very hard.
1. Unplug the iron from the mains socket, set the
2. Set the temperature selector to the "max"
3. After the necessary warm-up period, the
4. Hold the iron over a sink. Press the "clean"
5. Release the "clean" button, and gently shake
6. Repeat the steps 4 and 5 three times until
7. Unplug the iron and let the soleplate cool down.
3. anti-calc
The "anti-calc" cartridge has been designed to
reduce the build-up of scale produced during
steam ironing, helping to extend the useful life of
your iron. Nevertheless the "anti-calc" cartridge
cannot remove all of the scale that is produced
naturally over time.
4. Calc'nClean with descaling liquid
For deep descaling, it is recommended to use the
descaling liquid especially developed by Bosch.
This procedure should be carried out every 3
months.
• Fill the water tank with tap water mixed with a
• Then follow the procedure described above in
Multiple descaling
9
system
steam regulator to the position and ill the
water tank with water.
position and plug in the iron.
lamp goes out. Then, unplug the iron (very
important!).
button and shake the iron until approximately
one third of the water capacity of the tank is
evaporated. Boiling water and steam will come
out, carrying scale or deposits that might be
there.
the iron for some seconds,
the tank is empty. Then plug the iron in and
heat it up again until the remaining water has
evaporated.
Wipe the soleplate with a damp cotton cloth only.
measure (25 ml) of the descaling luid.
section "Calc'nClean" (steps 2 to 7)