Cable Connection - GEV CVS 088351 Bedienungsanleitung

Optional:
WIRING DIAGRAM 2 Monitors and
2 Outdoor stations
DIP Setting
MASTER
DIP Setting
SLAVE
DIP Setting
MASTER
DIP Setting
SLAVE

Cable connection

Connect the monitor to the camera and the door
opener with the cables according to the wiring
diagram.
Carefully insert the wires to the terminal by pressing
down the terminal fl ap with any small tool taking care
that the 2 bare wires do not touch.
Make absolutely sure that no bare wires are touching
each other after the connection!
Installation height
Recommended installation height is approximately
140 cm for monitor unit and 150 cm for outdoor
camera.
40°
70°
Tip: please make sure you found the optimal
installation height prior to having fi xed the outdoor
unit to the wall.
Installation of indoor monitor
1
1. Fix the wall mounting bracket in the best place by
using 4 screws and plugs (fi g. 1). Wire the monitor
as described in the diagram and connect the power
supply.
2. Carefully place the indoor monitor against the
bracket and gently push down the monitor so that
the pins on the bracket engage in the slots on the
rear of the monitor (fi g. 2). Hold tight the monitor until
the installation is fi nished.
3. Secure the assembly with the 2 screws from
underneath (fi g. 3).
Only after having connected the roadside
panel, connect the 230 V~ power supply to
the adapter.
Installation of the outdoor device
A
C
1. Remove the front panel (fi g. B). In the fi rst
loosen the two screws on the bottom (fi g. A). 2.
Attach the external station to the intended location
on the wall using wall plugs and screws (fi g. C).
Connect the outdoor unit to the cables brought
forward. At this point, you have the possibility
to adjust the camera's
manually. Aim the camera in the desired
position. 3. Screw the front panel again
(fi g. D).
Important: do not point the video camera directly at
the sun or at refl ecting surfaces.
Tip: we recommend passing the cables through a
7
2 3
B
D
module angle slightly