Kingstone 24592613 Aufbau- Und Bedienungsanleitung Seite 26

GB-BAHAG HSS ANLEITUNG 29092020 RZ.qxp 29.09.20 14:14 Seite 26
Wing nut
Reflector
Controller
Gas cartridge
WARNING: A leak test must be performed annually and each time a cylinder is hooked up or if a part of
the gas system is replaced.
WARNING: Never use an open flame to check for gas leaks. Be certain that no sparks or open flames are
in the area while you check for leaks. Sparks or open flames will result in a fire or explosion, which may
damage property and can cause serious bodily injuries, or death.
Leak testing: This must be done before initial use, annually, and whenever any gas components are
replaced or serviced. Do not smoke while performing this test, and remove all sources of ignition.
Turn all burner controls to the OFF position. Turn gas supply valve on.
Brush a half-and-half solution of liquid soap and water onto all joints and connections of the regulator,
hose, manifolds and valves.
Bubbles will indicate a gas leak. Either tighten the loose joint or have the part
replaced with one recommended by the customer care department and have the patio heater
inspected by a certified gas installer.
If the leak cannot be stopped, immediately shut off the gas supply,
disconnect it and have the patio heater inspected by a certified gas installer or dealer.
Do not use the patio heater until the leak has been corrected.
26
Step 7
Tighten the heat reflector with 3 further washers
and 3 wing nuts.
Hardware used
GG
Washer Ø 8 mm
KK
Wing nut
Step 8
8.1 Now lift the housing again.
8.2 Connect the gas tank to the controller and
tighten the connection with a wrench.
8.3 Now connect the gas hose to the controller.
8.4 Put the gas tank into the base now.
8.5 Fasten the gas cylinder with gas cylinder fixing strap.
x 3
x 3