Kingstone 24592613 Aufbau- Und Bedienungsanleitung Seite 23

GB-BAHAG HSS ANLEITUNG 29092020 RZ.qxp 29.09.20 14:14 Seite 23
Hardware contents
Before installation
To protect the radiant heater from tipping over, e.g. due to strong wind, you should
fasten the base of the radiant heater to the ground by the corresponding screws or anchors.
1. Turn the base around and install the fastening angle as displayed.
2. Push one M6 x 10 mm screw each through from the outside and apply a
washer from the inside. Then turn on one M6 nut each and tighten it.
3. Proceed according to the same pattern for the other 2 fastenings.
Part Description
BB
CC
DD
EE
FF
GG
HH
II
JJ
KK Wing nut
LL Wrench
MM Ground fixer
NN Bolt M6 x 10 mm
OO Washer 6 mm
PP Nut M6
Quantity
3
6
4
6
3
9
9
9
9
3
1
3
6
6
6
23