Kingstone 24592613 Aufbau- Und Bedienungsanleitung Seite 25

GB-BAHAG HSS ANLEITUNG 29092020 RZ.qxp 29.09.20 14:14 Seite 25
Bolts
Reflector spacer
Cap nut
Reflector part
Step 4
4.1 Remove the 4 bolts from the burner.
4.2 Push the gas hose/gas tube into the gas supply connection of the burner.
4.3 Tighten it.
4.4 Now attach the burner to the post with the 4 stainless steel bolts.
Hardware used
DD
Stainless steel bolt
Step 5
5.1 Ensure that the post, burner and bolts are connected as described.
5.2 Push the 8 mm washers onto each of the reflector spacers for the
heat reflector.
Hardware used
FF
Reflector spacer
GG
Washer Ø 8 mm
Step 6
Washer
Assemble the heat reflector with 3 bolts from below, put on
the washers from above, then screw on the nuts hand-tight at
Reflector
first and install the reflector centre with 6 more bolts.
lid
Then tighten all bolts.
Hardware used
HH
Washer Ø 6 mm
II
Bolt M6 x 10 mm
Bolt
JJ
Cap nut
x 4
x 3
x 6
x 9
x 9
x 9
25