Anker PowerWave Magnetic 2-in-1 Stand Lite Bedienungsanleitung Seite 3

EN
LED Indicator
Solid white for 4 seconds,
then turns off
Left LED indicator: Solid white
Right LED indicator: Solid white
Flashing
• This wireless charger is not compatible with non-Magsafe phone
T
cases, such as Otterbox Defender cases.
• Connect the wireless charger to a Quick Charge 2.0/3.0 or Power
Delivery wall adapter. Do not connect to a 5V/1A wall charger or
a USB port on a computer as it may affect the wireless charging
function.
• Do not place any foreign objects between your device and the
wireless charger's surface, including metal pads on a car mount,
magnetic cards, door keys, coins, NFC cards or other metal
objects, as they could potentially demagnetize the wireless
charger, affect the charging speed, or cause overheating.
• Wireless chargers make charging more convenient than wired
chargers, but confined by current wireless technology, their
charging speed is slower than that of wired chargers.
• High temperatures will reduce charging speed and restrict power.
It is recommended that you charge your device in environments
with temperatures below 35°C / 95°F.
01
Status
Connected to power
Charging your phone
Charging your wireless earbuds
• Metal objects detected
• Incompatible AC adapter connected,
indicating that you need to switch
to a Quick Charge 2.0/3.0 or Power
Delivery adapter
Important Safety Instructions
Please refer to the electrical and safety information on the
bottom before installing or operating the product.
•Avoid dropping.
•Do not disassemble.
•Do not expose to liquids.
•For the safest and fastest charge, use original or certified cables.
•This product is suitable for moderate climates only.
•The maximum ambient temperature during use of this product must
not exceed 40°C.
•Open flame sources, such as candles, must not be placed on this
product.
•Only use a dry cloth or brush to clean this product.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures: (1) Reorient or relocate the receiving antenna. (2)
Increase the separation between the equipment and receiver. (3) Connect
the equipment into an outlet on a circuit different from that to which the
receiver is connected. (4) Consult the dealer or an experienced radio / TV
technician for help.
02