Werbung
Initialisation
Before putting the table into operation:
•
crew all components tightly together
•
attach the power supply (7) to the table using clamp (L)
•
fi x all cables using cable holders (O) and (N)
•
Keep in mind that your desk is height adjustable. The power supply cable must be able to follow the
movement of the desk completely
•
Now please perform the initial Reset
•
Carry out a "Reset" at regular intervals - at least 1 x per month.
When putting your table into service fort he fi rst time, please perform a reset:
Press the paddle down until the table has
moved to the lowest position
RESET
Release the paddle
Press the paddle down again for at least
6 seconds. Don't release earlier.
Your frame can now be used normally. By pressing the paddle up or down the table moves as you wish and
stops, as soon as you release the paddle.
Troubleshooting
Problem
Height adjustment
does not work
If your problem couldn´t be solved or is not listed here, please contact your customer service for further
advise.
12
VXMST
RESET-mode VXMST
Possible cause
Cables or connectors defective
Table is slanted
Lifting columns not syncronized
Fault in the conrol unit
Max. continuous use time exceeded
(duty cycle)
Table moves down
Lifting columns move down a bit further to
their mechanical limit to synchronize
Solution
Check all cables and connections.
Check your wall outlet.
Bring your table into a level position
Perform a Reset
Let the unit cool down for
20 Minutes
Werbung
Fehlerbehebung
