Installing The Board In The Aj-Spd850 Series - Panasonic AJ-YAD850G Bedienungsanleitung

Installing the board in the AJ-SPD850 series

CAUTION:
These servicing instructions are for use by qualified service
personnel only. To reduce the risk of fire or electric shock do not
perform any servicing other than that contained in the operating
instructions unless you are qualified to do so.
The AJ-YAD850G must be installed in the AJ-SPD850 in order for it to be used. Follow
the procedure below for installation.
1
Disconnect the power cord from the
unit.
2
Check that the DIP switches on the
AJ-YAD850G are set to the positions
shown in the figure below.
3
Remove the 2 coin screws and top
panel from the unit.
1
2
3
4
5
4
Remove the screw and the board
clamp.
Board clamp
1
2
3
4
5
3(E)
5
SW301
4 3 2
1
ON
6
Coin screws
Screw
Remove the screw and remove the
connector board from the rear panel.
Connect the accessory cable to the
terminal board through the hole for
the F3 slot.
Connector
board
Cable
Connector
board
Screw