Scott Safety Spirit Technische Beschreibung Seite 7

Remember to close the buckle after
adjustment.
DOFFING
CAUTION
Do not remove the headtop until you
are in a safe and hazard free zone.
Once free of any hazard switch off
the blower.
If wearing FH1 then simply pull the
visor away from the face with the
locating tag and lift off the headtop.
With FH2 and FH21 gather up the
neck cape, pull the visor away from
the face and lift off the headtop.
Place the headtop onto a clean
surface.
Remove the PAPR in accordance
with the Operating and Maintenance
instructions.
Proceed with after use cleaning and
storage.
AFTER USE CARE
Note If during use the equipment
may have become contaminated
by hazardous
contamination must be identified
and properly
contaminated components must be
replaced before next use.
Disposal of
components must be carried out
in accordance with local regulatory
requirements.
substances,
removed or
the contaminated
Disconnect the breathing hose from
the blower.
Inspect the headtop for worn, ageing
or damaged components.
Carefully wash or wipe clean the
headtop and wipe clean the blower
with a warm water solution containing
a mild detergent.
It is recommended that headtop
visors be wiped clean with Distel
wipes
If necessary, wash the outside of the
breathing hose carefully using warm
water solution containing a mild
detergent.
Ensure
connections are free from all dirt or
debris that could prevent an effective
seal with the blower
Once clean all components must be
left to dry naturally.
STORAGE
Device must be protected from
damage during transportation.
When not in use the equipment
should be stored in a clean, dry
environment, away from direct heat
sources between +10°C and +30°C, at
a humidity of less than 65% RH.
DISPOSAL
Disposal of the components must be
carried out in accordance with local
regulatory requirements.
the
SPARES
Replacement parts and accessories
the
may be ordered through Scott Safety
customer services. The department
can also provide general information
on other Scott Safety products.
7
the breathing
FH1, FH2, FH21
®
hose