eta FRISK Bedienungsanleitung Seite 27

GB
You activate the function basically by pouring water into the container A9. The appliance
notices the water and turns on the humidifying indicator B18. When the indicator turns off,
you need to pour water to continue. Replace the water which was not used regularly!
AROMATHERAPY FUNCTION
Slight an aroma container A13 out of the appliance, open it (pic. 2) and add a few drops
of aroma oil on the filter that is placed in the container (in case of maintenance, put it back
in the container). Close the container and put it back into the appliance. Thanks to this the
flowing air will be aromatized.
FILTERS EXCHANGE AND CLEANING
To replace or maintain the filters, simply proceed according to Fig. 2. In order to insert
parts back to the appliance, proceed with the reversed way. When the filter replacement
indicator B15 comes on, it indicates the end of the filter service life. The HEPA filter
indicator (marked as 2 on the panel) will come on after 2500 hours of operation, which
corresponds to approximately six months of intensive use - after this time, the filter needs
to be replaced (unless it was replaced earlier due to contamination and higher dust level in
the surroundings). The carbon filter indicator (marked as 3 on the panel) will come on after
2500 hours of operation and the humidification filter A8 (marked as 4 on the panel) will
come on after 2500 hours of operation. The appliance also features a notification of regular
pre-filter A5 (1) and humidifying filter A8 (4). When the filter cleaning indicator B14 turns
on, clean the filters. To restart the indication, press the button B5 and hold it for several
seconds.
IV. MAINTENANCE
The maintenance of this air purifier resides in cleaning of the unit´s body, cleaning of
the humidifying part´s set and exchange of filters. Before you start any maintenance or
exchange of filters, turn off the appliance at first and unplug it.
Power unit
Only clean the power unit body with slightly damped cloth with non-aggressive cleaning
agent added. Do not allow water to get inside! Let the purifier thoroughly dry out before
using it again.
HEPA filter A3
To guarantee proper function and air purification quality, HEPA filter must be replaced in
regular intervals. Never wash the filter to avoid reducing the filtration capacity of the filter;
only knock it out, vacuum or blow it with compressed air – however this will not fully restore
the filtration capacity of the filter.
Order code for a new filter: ETA556990100
Carbon filter A4
So that the carbon filter maintains its filtration properties, it needs to be replaced at regular
intervals. Do not wash the filter, it can only be cleaned with a soft brush, vacuum cleaned or
cleaned with compressed air. However, the filter will not regain its odour absorption ability
this way.
27 / 55