Cleaning And Maintenance - KIKKA BOO DESSINE MOI Gebrauchsanweisung

WARNINGS
• Never leave your child unattended. Always keep your child in view. if you leave the child unattended in the cot, always make sure that the movable side is closed.
• Never leave items inside the cot that may act as support for the baby's feet and aid the baby in climbing out of the cot.
• Keep the cot away from any loose cables or cords.
• Do not use more than one mattress in the cot.
• ONLY USE THE MATTRESS SOLD WITH THIS COT, DO NOT ADD A SECOND MATTRESS ON THIS ONE, SUFFOCATION HAZARDS (FIGURE A)
.
• The mattress base complies with: EN 716-1.
• Inspect the product for damaged hardware, loose joints, missing parts or sharp edges. The cot should not be used if the fabric is torn or damaged.
• Before each use, please check that all the upper egdes of the cot are properly locked.
• Discontinue using the cot when the child reaches 86cm in height, weighs more than 14kg or is able to climb out.
• To prevent injury from falls that when the child is able to climb out of the cot, the cot shall no longer be used for that child.
• Never put more than one child at once into the cot.
• When folded, store away from children.
• A cot is only ready for use when the locking mechanisms are engaged. Check carefully that locking systems are fully engaged before using the folding cot.
• Never leave the cot exposed to direct sunlight. Never put ngers inside the corners or any other moving parts of the cot while folding and unfolding the cot.
• Never use playard without a mattress. Always use the mattress provided with xings to the underside. This travel cot is sold with a base hardcover mattress speci cally designed to
avoid any danger of su ocation. Only use the mattress provided.
• Product complies with: EN 716-1:2017+AC:2019 & EN 716-2:2017
• Be aware of the risk of open re and other sources of strong heat such as electric bar res, gas res etc. in the near vicinity of the cot.
• Do not use the cot if any parts is broken, torn or missing and use only spare parts approved by the manufacturer.
• Do not leave anything in the cot or place the cot close to another product, which could provide a foothold or present a danger of su ocation or strangulation, e.g. strings,
blind/curtain cords etc.
• All assembly ttings should always be tightened properly and that ttings should be checked regularly and retightened as necessary.
BOX CONTENTS: Compact travel cot; Lift (in a two-level set); Padded Base; Carrying bag
UNFOLDING THE COT
Unfasten the zipper on the carrier bag and take the cot out of the bag. (1). Unfasten the velcro slaps on the mattress wrapping the cot (2). Take the cot out and put the mattress aside
(3). Unfold all four corners of the cot, so you can grab the locks in the middle of the sides of the cot.
With a rm move, lift the cot's sides until they lock (3). Litt the long sides rst, then the short sides.
WARNING: Before using the cot, please make sure that the side rails are correctly locked!
Press on the center of the cot's oor until it is fully at and locked (4). Place the mattress in the cot with the soft side upwards (5). Attach the mattress to the oor with the velcro straps
located under the mattress.
INSTALLING THE SECOND FLOOR LEVEL
Install the second oor level with the zipper on the sides of the oor and the sides of the cot (6). Insert the tips of 4 metal tubes into the pockets on top of the second oor level and
connect the tubes (7). Wrap the velcro straps around the tubes to secure them. Place the mattress on top of the oor and attach it to the oor with the velcro straps under the mattress
(8).
The height of the cot base is adjustable. The lowest position is the safest and the base should always be used in that position as soon as the baby is old enough to sit up.
Where detachable support rails are provided to support the cot base above its lowest position, it is essential to remove these rails before the cot is used in its lowest position.
INSTALLATION AND USE OF THE CHANGING PAD
Take the changing pad out of the box. Insert the side metal tubes into the pockets on the sides of the changing pad (9). Take the tubes with the feet and connect them with the side
tubes by pressing the metal buttons and inserting the tubes into the side tubes until the metal buttons lock in the holes (10). Secure the corners and the side tubes by covering them
with the textile straps and connecting them with the base of the changing pad with the snap buttons (11). Make sure all the tubes are properly connected. Unproper installation of
the changing pad may cause injuries to the baby. Lock the feet of the changing pad on the longer sides of the cot (12). Additionally attach the textile part of the changing pad to the
shorter side of the cot by connecting the fasteners to the loops on that side. When the changing pad is not used, detach the feet o the sides of the cot and swing the pad to the side.
Changing pad complies with EN 12221-1:2008+A1:2013& EN 12221-2:2008+A1:2013
WARNING: Use this changing pad only with the cot it was designed to be used with. DO NOT use the changing pad with any other cot. Using this changing pad with other cots may
cause serious danger. All the parts of the changin pad should be always properly locked and regularly checked. NO NOT use the changing pad without placing it on the cot. BEFORE
installing the changing pad on the cot, make sure all parts are in proper shape.
DO NOT use the changing pad if any part of it is broken, torn or missing. Maximum weight of a child placed on the changing pad is up to 11 kg.
FOLDING THE COT
Remove the mattress and lay it aside (13). Lift the middle of the cot' s oor as high as possible (14). Locate the buttons on the bottom of the locks in the middle of each side of the cot.
Press the buttons on both long sides of the cot and lower the sides (15). Repeat these actions for the short sides.
WARNING: The buttons are located under the upholstery on the cot' s sides. The cot' s center must be raised high for the buttons to work properly. Never use force as this may damage
the cot.
If pressing the buttons does not allow to fold the sides, press the cot' s base down and repeat all above steps. Fold all cot' s legs together. Take the mattress and wrap it around the cot
(16). Lock the package by fastening the velcro straps on the mattress. Put the cot into the carrier bag and fasten the zipper (17).

CLEANING AND MAINTENANCE

Clean the plastic parts with damp cloth and soap.
The textiles should be cleaned with a damp cloth and a mild detergent.
Do not place the cot in direct sunlight or near heat sources. It may damage the cot. The cot is designed to be used inside buildings, in room temperature.
ENGLISH