Flip Function; Speed Control - Modster FOLD 4K Betriebsanleitung

Manual
Flight Adjustment Section
When you lift your drone in the air without using any other buttons or levers, your drone should simply hover in one spot without moving
in any other direction. However, if it does not do so, you can follow the instructions below to return to perfect hovering (TRIM). TRIMMING is
always need before your first flight.
Tip: It is much easier to learn flying, if you ignore the turn right/turn left. You can also fly the drone by using the other levers and buttons.

Flip Function

1. Make sure the drone is flying at least 3 metres above the floor and 3 metres below the ceiling.
2. Press the flip button on the controller. The controller will make a „Beep" sound. Then flick the
right hand lever in a specific direction and the drone will flip in that direction.
3. You may need to move the Up/Down lever up after the flip, if your battery is low in order to
keep your drone in the air.

Speed Control

When you first turn on your drone, it is set to 25% speed. You will hear ONE beep sound. When you press the SPEED BUTTON, you will hear
TWO beep sounds and the speed will increase to 50%. When you press the SPEED BUTTON again you will hear THREE beep sounds and the
speed will increase to 100 percent. Using the SPEED BUTTON another time means returning to 25% speed. You will hear one beep sound.
Learn to fly at 25% speed. You can increase it, when you have improved your flying.
Headless & One Key Return Function
Headless function: Press the Trim slider button to
the left. You will get into compass mode. To quit com-
pass mode, you have to press the sam slider button.
www.modster.at
MODSTER FOLD 4K
One Key Return function: Press the trim slider but-
ton and you´ll get in the „One Key Return" mode. To
quit the mode press the same button again.
25