Modster FOLD 4K Betriebsanleitung Seite 22

Manual
Install the Protector:
Pull the accessory as Pic 1 and press the locking plate on the protector, as the same time push-in the protector as Pic 2, the protector is instal-
led finish.
Charging Your Drone Battery
Battery Warning:
Lithium Polymer batteries can expand, burst or catch fire if used incorrectly, causing both properly damage and/or personal injury. It is essen-
tial to follow all the included instructions and safety warnings in full. The manufacturer, distributors and retailers will assume no liability for
the failure, which might comply with these safety instructions and warnings.
CAUTION: Please cool down the drone always after each flight with the drone for at least 10 minutes.
Instructions when Charging:
1. The battery must be removed from the product before charging.
2. If the battery has just been used, please let it cool down to room temperature before charging.
3. Charging must only be undertaken by an adult and only using the charger included with this product.
4. Always charge the battery on a non-flammable, heat-resistent surface with non-flammable surroundings.
5. Connect the battery to the USB charging cable.
6. Connect the USB charging cable to your USB charging devices the red LED on the battery will light up while charging and will turn off
once the battery is fully charged. It takes around 60-70 minutes to fully charge the battery. Never continue to charge the battery after
the red LED has turned off. Charging the battery completly you will need at least 10 minutes.
7. Lithium Polymer batteries do not last forever. If your battery becomes damaged in a crash or no longer charges properly, immediately
replace it with a new battery. To prolong the life of your battery it is always the best to retain a bit of charge in your battery prior to char-
ging it.
Safe Flight Environment
1. Make sure that the surrounding area is free of people, pets or other obstacles before you start to fly.
2. The drone is designed for outdoor or inddor flying depending on how much space is available.
3. Always leave 1,5 meters between you and the drone
4. Setup
Setting up the signal connection:
Step 1: Insert the battery to the battery housing (first picture). Turn on the power switch of the drone - the LEDs on the Drone will start to
flash. Place the drone down on a flat surface, making sure the drone is facing away from you.
22
MODSTER FOLD 4K
www.modster.at