Modster FOLD 4K Betriebsanleitung Seite 23

Manual
Step 2: Press down the controller power switch to
turn on the power. The controller will make one short
beep sound and the red LED will flash. To pair the si-
gnals of the vision drone and the controller, you must
RAISE the UP/DOWN lever on the controller all the way
to the top. And then LOWER it to the bottom. It will
make one short beep sound. The next time you RAISE
the UP/DOWN lever the drone will lift into the air.
5. Match the Frequency
Turn on the drone and remote control after the drone LED light blink quickly. Push the
left stick of the remote control to the highest point and then pull to the lowest point.
After the remote control send a „beep" sound the frequency matching is finished and
the drone LED light becomes steady.
6. Auto Trim Function
Push both controler sticks to the position as shown on the picture and hold them for
a few seconds. The lights on the drone will start to flash. Now the drone is recoverd to
its original factory settings and ready to fly again.
www.modster.at
Step 3: Always turn off the
power switch of the drone after
flight.
Step 4: Always turn the cont-
roller off after flight and remo-
ve all the batteries if you leave
it unused for a long period of
time.
MODSTER FOLD 4K
Step 5: Please remove the battery by pres-
sing down the tap on the battery and extract
the battery. The first attempts could be more
sluggish then the next ones.
23