Suntec Wellness KLIMATRONIC 16349 DryFix 20 MAX Bedienungsanleitung Seite 18

Child Lock
- Press and hold this button for 3 seconds to turn the child lock on and off.
Sleep / Reset
Sleep
Please press the Sleep / Reset button, the display will light up and activate the sleep mode; touch the
button again to exit the function.
In sleep mode, the fan speed will be automatically switched to the low speed, and after no operation for
10 seconds, except for the sleep mode, operation, water tank full and child lock indicator light, all other
indicator lights and the screen will be turned off.
When the room humidity rises above 57%, the compressor will stop operating and the fan will stop
operating after 30 seconds.
When the room humidity drops below 63%, the fan starts working and the compressor follows working
after 3 seconds.
The fan speed and humidity setting function is not available in this mode, you cannot set the humidity
value and fan speed.
When the water tank is full in sleep mode, the unit will not sound an alarm, but the full water tank
indicator light ( ) will light up (red) to remind you that the water tank is full and you need to empty the
water tank to continue operation.
Reset
Please press and hold the Sleep / Reset button for 3 seconds to reset the air filter. When the unit has
been operating for 600 hours, the air filter indicator will light up to remind you to clean the air filter.
Please note that the unit will not work until you clean the air filter and long press the button to reset the
air filter.
Light indication
- If the ambient humidity is below 45%, the indicator light will turn blue.
- If the ambient humidity is between 45% and 65%, the indicator light will be in green.
- If the ambient air humidity is above 65%, the control light is red.
CONDENSATION WATER DRAINAGE
Water tank:
- As soon as the water tank is full, a warning tone sounds five times and the symbol above the timer
button lights up on the display.
- The machine stops operating.
- Please turn off the power and unplug the power cord.
- Pull out the water tank carefully, remove the tank lid and tilt the water out.
- Then put the lid back on and slide the water tank carefully into the device.