Werbung
Verfügbare Sprachen
Verfügbare Sprachen
To wall mount:
1. Secure the bracket onto a desired wall using the screws and plastic
anchors.
2. Clip the remote temperature sensor onto the bracket.
Note:
Before permanently fixing the sensor wall base, place all units in the
desired locations to check that the outdoor temperature reading is
receivable. In event that the signal is not received, relocate the sensors
or move them slightly as this may help the signal reception.
Care and maintenance:
Extreme temperatures, vibration and shock should be avoided as
these may cause damage to the unit and give inaccurate forecasts
and readings.
Precautions shall be taken when handling the batteries. Injuries,
burns, or property damage may be resulted if the batteries are in
contact with conducting materials, heat, corrosive materials or
explosives. The batteries shall be taken out from the unit before
the product is to be stored for a long period of time.
Immediately remove all low powered batteries to avoid leakage
and damage. Replace only with new batteries of the recommended
type.
When cleaning the display and casings, use a soft damp cloth
only. Do not use solvents or scouring agents as they may mark the
LCD and casings.
Do not submerge the unit in water.
Special care shall be taken when handling a damaged LCD
display. The liquid crystals can be harmful to user's health.
Do not make any repair attempts to the unit. Return them to their
original point of purchase for repair by a qualified engineer.
Opening and tampering with the unit may invalidate their
guarantee.
Never touch the exposed electronic circuit of the device as there is
a danger of electric shock should it become exposed.
Do not expose the units to extreme and sudden temperature
changes, this may lead to rapid changes in forecasts and readings
and thereby reduce their accuracy.
EN12
Werbung
