Functional Description - Lindemann LIMETREE NETWORK II Bedienungsanleitung

22 EN EN

FUNCTIONAL DESCRIPTION

Limetree
on
1
1. The toggle switch on the front of the network player has two
functions:
a) Push it up briefly to turn the unit on. A second short push will
turn the unit off again.
b) For a hardware reset hold the toggle switch for ten seconds in
the upper position. The Power indicator (LED) will start flashing
rapidly and the device will reboot with the default settings.
Note: after turn-on the device will need some time to boot. The
unit is ready for use when the Sample Rate LED is lit. After
turn-off the Power LED will flash until the unit has shut down.
Network
SR DSD
2 3 4
5
2. Function indicator of the input signal sampling rate:
the color of this LED will change along with input
signal sampling rate.
Green
Cyan
Blue
White
Yellow
Orange
Purple
3. Function indicator for the DSD mode: when the LED is
lit yellow, the device is in the DSD mode. When the LED
is dark, the device is in PCM mode.
4. Headphone socket 3.5 mm: plugging in the headphone
will activate the headphone output and the line output
is muted.
5. Infrared receiver for the IR remote control.
PCM 44.1/48 kHz
PCM 88.2/96 kHz
PCM 176.4/192 kHz
PCM 352.8/384 kHz
DSD 64
DSD 128
DSD 256

Top