Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. Important information
Please read this manual completely and attentively before using
the product for the first time. Keep this manual. It is part of the
product.
1.1 Safety instructions
Caution:
Risk of injury!
Due to the detailed reproduction of the original and the
intended use, this product can have peaks, edges and break-
able parts. For installation tools are required.
Electrical hazard!
Never put the connecting wires into a power socket!
Regularly examine the transformer for damage.
In case of any damage, do not use the transformer.
Make sure that the power supply is switched off when you
mount the device and connect the cables!
Only use VDE/EN tested special model train transformers
for the power supply!
The power sources must be protected to prevent the risk of
burning cables.
1.2 Using the product for its correct purpose
This product is intended:
-
For installation in model train layouts and dioramas.
- For connection to an authorized model train transformer
(e. g. item 5200) or a digital command station.
-
For operation in dry rooms only.
Using the product for any other purpose is not approved and is
considered incorrect. The manufacturer is not responsible for
any damage resulting from the improper use of this product.
1.3 Checking the package contents
Check the contents of the package for completeness:
-
LED with connection cables
-
2 heat shrink tubes
-
Lamp shade
-
Lamp glass / lamp lid
-
Colour filter (not with all models)
-
Lamp mast
-
Base socket
-
Resistor (different coloured rings)
-
Diode (only one ring)
-
Manual
2. Introduction
This lamp produces the light by SMD-LEDs which is suitable
to the lamp model. Low heat build-up and power input. Nearly
unlimited lifetime of the LED, so no more change is required.
3. Assembly
- See page 2 chapter 3 „Zusammenbau/Assembly".
4
EN
4. Mounting
-
Check function before mounting.
-
Drill a hole (Ø 6 mm) at the mounting place (fig. 1).
-
Put the base socket with the cables from above through the
hole.
Caution:
Never touch the mast but only the base socket (fig. 3).
When connecting the cables, please leave a loop of ca. 2 – 3
cm behind the lamp, which enables you to pull the lamp out of
the assembly drilling.
Caution:
Resistor and diode at the cables are needed for proper func-
tion of the lamp. Never cut them off! Never cover resistor or
diode with insulation material, because they have to be cooled
by surrounding air!
5. Connection
Connect the LED-lamp to the light output of a model train trans-
former (e. g. item 5200) as shown in fig. 4 and/or 5.
DC voltage: Connect the diode with the positive pole and the
resistor with the negative pole of the power supply.
AC voltage: Operation with AC voltage could cause some
flickering. We recommend to use the Viessmann power module
item 5215 (fig. 5) which is sufficient for ca. 100 LED-lamps or
reflectors. Connect the cable with the diode to the brown output
socket and the cable with the resistor to the red output socket
(fig. 4).
6. Technical data
Operating voltage:
(with and without 5215 power module),
Operating current:
10 – 16 V AC ~
14 – 24 V DC =,
13 – 24 V digital signal
ca. 10 mA
5
Werbung
