Bosch TDA 46 Series sensixx B3 Bedienungsanleitung Seite 13

Trouble shooting guide for minor issues
Problem
The iron does 1. Temperature control
not heat up. dial in very low
position.
2. No mains supply.
The pilot light 1. The iron is cooling.
does not switch 2. The iron does not
on. heat up.
The clothes 1. The temperature is
tend to stick. too high.
Water comes 1. Temperature
out together regulator in very low
with steam. position.
2. Steam regulator in
very high position with
low temperature.
Steam does 1. Steam regulator in
not come out. closed position
2. No water in the tank.
3. The temperature
is too low. Anti-drip
system not activated.
Spray does not 1. No water in the tank.
work. 2. Obstructed
mechanism.
Water drips 1. The steam regulator
out of the is not properly closed.
soleplate.
Smoke comes 1. Lubrication of some
out when of the internal parts.
connecting the
iron for the first
time.
You can download this manual from the local homepages of Bosch
Probable cause
.
Solution
1. Turn to a higher position.
2. Check with another appliance
or plug the iron into a different
socket.
1. Wait until the heating cycle is
completed.
2. See previous paragraph.
1. Turn the temperature control
dial down and wait until the iron
has cooled down.
1. Turn the temperature control
dial regulator to a higher position
and wait until the operating
indicator switches off.
2. Turn the steam regulator to a
lower position.
1. Turn the steam regulator to an
open steam position.
2. Fill the tank.
3. Set a higher temperature if
compatible with the fabric.
1. Fill the water tank.
2. Contact the Technical Service.
1. Ensure the steam regulator is
set to the position
Do not forget to empty the tank
when you have finished ironing.
1. This is normal and will stop
after a few minutes.
en
.
13