Overheat Protection; Cleaning And Maintenance; Technical Specification - N'oveen HC1500 Benutzerhandbuch

OVERHEAT PROTECTION

The heater is protected with an overheat protector that switches off the heater automatically
in case of overheat. e.g. due to the total or partial obstruction of the grids. In this case,
unplug the appliance, wait about 30 minutes for it to cool and remove the object which is
obstructing the grids. Then switch it back on as described above.
NOTE: After switching off, the fan runs for about 30 seconds to cool down the appliance.

CLEANING AND MAINTENANCE

1. If you don't use the heater for a long time, please wipe the surface and put it into the box.
Lay the carton on the ventilated and dry place.
2. Wait for the machine being cool and pull out the plug, then clean it. Wipe it clean with wet
washcloth or cleaner. Never directly wash with water; do not drop the water into the
machine. Never clean it with acids, chemical thinner, gasoline, benzene etc.
3. Before use it again, please check it and make sure the outlet ventilation have no any
sundries.

TECHNICAL SPECIFICATION

Power: 2000 W
Voltage: 220-240 V ~ 50 Hz (HC1500/HC2000) / 220-240 V ~ 50/60 Hz (HC2100/HC2200)
Remote control
40