Installation Of The Appliance - N'oveen HC1500 Benutzerhandbuch

INSTALLATION OF THE APPLIANCE

The heater should be installed and used according to the safe standard.
To avoid all dangers, follow the safety instructions.
- The installation must be done by the service agent or similarly qualified persons in order to
avoid a hazard.
- Important! Make sure that there are no electric cables or other installations (for example
water pipes) near the drill holes. Make sure that the appliance is securely and vertically
fitted to the wall.
Get two holes on the wall 2 m above the floor and near the corner more 0,25 m, be sure to
make the diameter just as same as the expanding pipe. Fix two screws on the expanding
pipe, keep the tips of the screws out for 10mm, and hang up the machine after the screws
are fixed enough.
HC1500/HC2000/HC2050:
385 mm
HC2100: 535 mm
HC2200: 545 mm
HC2500: 330 mm
HC3100/3200: 330 mm
See Picture 1
OPERATION INSTRUCTIONS
1. Before inserting the plug into an electrical outlet, make sure that the electrical supply in
your area matches that on the rating label on the unit.
2. Carefully remove the heater from the plastic bag and the carton.
3. Place the heater on the wall, setting the master button to "-" position. Plug the cord set
into a AC220-240V~ electrical outlet, with "BEE" sounds the "Power" light is on and the
heater will shows the default temperature, it will twinkle 3 seconds.
1) SET TIME HC1500/HC2000 / HC2050 / HC2200
Before turn on the heater, set the right time. Press remote control " " button, control panel
shows current room temperature.
WEEK Press "Set" button one time, "I/W" (HC1500/HC2000/HC2050) or "W-Timer/W"
(HC2200) lights on, press " " buttons to set the week from 1-7 (1=Monday,
2=Tuesday...7=Sunday)
29